相关论文: BeamSync: Over-The-Air Carrier Synchronization in …
In conventional joint communications and sensing (JCAS) designs for multi-carrier multiple-input multiple-output (MIMO) systems, the dual-functional waveforms are often optimized for the whole frequency band, resulting in limited…
This paper considers a multiple-input multiple-output (MIMO) integrated sensing and communication (ISAC) system, where a multi-antenna base station (BS) with transceiver hybrid analog-digital arrays transmits dual-functional signals to…
In this paper we study energy efficient joint power allocation and beamforming for coordinated multicell multiuser downlink systems. The considered optimization problem is in a non-convex fractional form and hard to tackle. We propose to…
Communication at millimeter wave (mmWave) frequencies is defining a new era of wireless communication. The mmWave band offers higher bandwidth communication channels versus those presently used in commercial wireless systems. The…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
This work considers an uplink wireless communication system where multiple users with multiple antennas transmit data frames over dynamic channels. Previous studies have shown that multiple transmit and receive antennas can substantially…
The millimeter wave (mmWave) bands offer the possibility of orders of magnitude greater throughput for fifth generation (5G) cellular systems. However, since mmWave signals are highly susceptible to blockage, channel quality on any one…
The uplink where both the transmitter and receiver can use a large antenna array is considered. This is proposed as a method of antenna offloading and connecting small cell access points (SCAP) in a Two-Tier cellular network. Due to having…
Millimeter wave (mmWave) communication, utilizing beamforming techniques to address the inherent path loss limitation, is considered as one of the key technologies to support ever increasing high throughput and low latency demands of…
Recently, a technique called beam-space MIMO has been demonstrated as an effective approach for transmitting multiple signals while using a single RF-chain. In this work, we present novel design considerations and a compact antenna solution…
Over-the-air computation (AirComp) is considered as a communication-efficient solution for data aggregation and distributed learning by exploiting the superposition properties of wireless multi-access channels. However, AirComp is…
Accurate time synchronization is essential for Internet of Things (IoT) systems, where multiple distributed nodes must share a common time base for coordinated sensing and data fusion. However, conventional synchronization approaches suffer…
In this paper, linear beamforming design for amplify-and-forward relaying cellular networks is considered, in which base station, relay station and mobile terminals are all equipped with multiple antennas. The design is based on minimum…
A practical and scalable multicast beamformer design in multi-input multi-output~(MIMO) coded caching~(CC) systems is introduced in this paper. The proposed approach allows multicast transmission to multiple groups with partially…
Over-the-air computation (OAC) is a promising wireless communication method for aggregating data from many devices in dense wireless networks. The fundamental idea of OAC is to exploit signal superposition to compute functions of multiple…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Beamforming techniques are proposed for a joint multi-input-multi-output (MIMO) radar-communication (RadCom) system, where a single device acts both as a radar and a communication base station (BS) by simultaneously communicating with…
Increased capacity in the access network poses capacity challenges on the transport network due to the aggregated traffic. However, there are spatial and time correlation in the user data demands that could potentially be utilized. To that…
Integrated sensing and communication (ISAC) is expected to be one of the major features of 6G wireless networks. In an ISAC system, communications and sensing functionalities are jointly performed using the same waveform, frequency band and…
Wireless Power Transfer (WPT) is expected to be a technology reshaping the landscape of low-power applications such as the Internet of Things, Radio Frequency identification (RFID) networks, etc. Although there has been some progress…