相关论文: Efficient CI-Based One-Bit Precoding for Multiuser…

Aiming at overcoming practical issues of successive interference cancellation (SIC), this paper proposes a dual-polarized rate-splitting multiple access (RSMA) technique for a downlink massive multiple-input multiple-output (MIMO) network.…

This paper presents a mutual coupling based calibration method for time-division-duplex massive MIMO systems, which enables downlink precoding based on uplink channel estimates. The entire calibration procedure is carried out solely at the…

Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…

This paper studies the instantaneous rate maximization and the weighted sum delay minimization problems over a K-user multicast channel, where multiple antennas are available at the transmitter as well as at all the receivers. Motivated by…

We investigate massive multiple-input-multiple output (MIMO) uplink systems with 1-bit analog-to-digital converters (ADCs) on each receiver antenna. Receivers that rely on 1-bit ADC do not need energy-consuming interfaces such as automatic…

In frequency division duplex (FDD) massive MIMO systems, a major challenge lies in acquiring the downlink channel state information}\ (CSI) at the base station (BS) from limited feedback sent by the user equipment (UE). To tackle this…

Consider media streaming in MIMO interference networks whereby multiple base stations (BS) simultaneously deliver media to their associated users using fixed data rates. The performance is fundamentally limited by the cross-link…

In this work, we derive a lower bound on the training-based achievable downlink (DL) sum rate (SR) of a multi-user multiple-input-single-output (MISO) system operating in frequency-division-duplex (FDD) mode. Assuming linear minimum mean…

This paper studies the coordinated beamforming design problem for the multiple-input single-output (MISO) interference channel, assuming only channel distribution information (CDI) at the transmitters. Under a given requirement on the rate…

Stacked intelligent metasurface (SIM) is an emerging technology that uses multiple reconfigurable surface layers to enable flexible wave-based beamforming. In this paper, we focus on an \ac{SIM}-assisted multi-user multiple-input…

Base station cooperation can exploit knowledge of the users' channel state information (CSI) at the transmitters to manage co-channel interference. Users have to feedback CSI of the desired and interfering channels using finite-bandwidth…

Precoding is a method of compensating the channel at the transmitter. This work presents a novel method of data detection in turbo coded single user massive multiple input multiple output (MIMO) systems using precoding. We show via computer…

Active reconfigurable intelligent surface (RIS) is a new RIS architecture that can reflect and amplify communication signals. It can provide enhanced performance gain compared to the conventional passive RIS systems that can only reflect…

Considering backhaul consumption in practical systems, it may not be the best choice to engage all the time in full cooperative MIMO for interference mitigation. In this paper, we propose a novel downlink partial cooperative MIMO (Pco-MIMO)…

The downlink transmission in multi-user multiple-input multiple-output (MIMO) systems has been extensively studied from both communication-theoretic and information-theoretic perspectives. Most of these papers assume perfect/imperfect…

In this paper, we study the problem of digital pre/post-coding design in multiple-input multiple-output (MIMO) systems with 1-bit resolution per complex dimension. The optimal solution that maximizes the received signal-to-noise ratio…

Motivated by the demand for energy-efficient communication solutions in the next generation cellular network, a mixed-ADC architecture for massive multiple input multiple output (MIMO) systems is proposed, which differs from previous works…

In cell-free massive MIMO systems with multiple distributed access points (APs) serving multiple users over the same time-frequency resources, downlink beamforming is done through spatial precoding. Precoding vectors can be optimally…

There has been growing interest in implementing massive MIMO systems by one-bit analog-to-digital converters (ADCs), which have the benefit of reducing the power consumption and hardware complexity. One-bit MIMO detection arises in such a…

In this paper, we propose a sequential and incremental precoder design for downlink joint transmission (JT) network MIMO systems with imperfect backhaul links. The objective of our design is to minimize the maximum of the sub-stream mean…