相关论文: A Compact Size 5G Hairpin Bandpass Filter with Mul…

Designed an elliptical polarization conversion metasurface (PCM) for Ka-band applications, alongside a high-gain substrate integrated waveguide (SIW) antenna. The PCM elements are integrated into the antenna design in a chessboard array…

A real-time ranging lidar with 0.1 Mega Hertz update rate and few-micrometer resolution incorporating dispersive Fourier transformation and instantaneous microwave frequency measurement is proposed and demonstrated. As time-stretched…

This paper presents the experimental verification of a planar guided-wave terahertz (THz) spoof surface plasmon polariton (SSPP) bandpass filter (BPF) using a coplanar stripline (CPS) with internal grooves and periodic gaps. The proposed…

To this day, achieving broadband low-frequency sound absorption remains a challenge even with the possibilities promised by the advent of metamaterials and metasurfaces, especially when size and structural restrictions exist. Solving this…

The signal processing firmware that has been developed for the Low Frequency Aperture Array component of the Square Kilometre Array is described. The firmware is implemented on a dual FPGA board, that is capable of processing the streams…

This paper provides an overview of the features of fifth generation (5G) wireless communication systems now being developed for use in the millimeter wave (mmWave) frequency bands. Early results and key concepts of 5G networks are…

Modern magnetic resonance imaging (MRI) relies on application-specific multi-channel receive coils to achieve high performance, but these coils are typically costly, rigid, and difficult to generalize across anatomies. Recent wireless,…

We propose a learning-based method for the joint design of a transmit and receive filter, the constellation geometry and associated bit labeling, as well as a neural network (NN)-based detector. The method maximizes an achievable…

We have constructed several impedance-matched low-pass filters using a stripline geometry with a dissipative dielectric. The filters are compact, simple to construct, and operate in cryogenic environments. The dissipative dielectric…

Fifth generation (5G) cellular standards are set to utilize millimeter wave (mmWave) frequencies, which enable data speeds greater than 10 Gbps and sub-centimeter localization accuracy. These capabilities rely on accurate estimates of the…

Microwave photonic (MWP) filters are essential components in microwave systems due to their wide bandwidth, low loss, and immunity to electromagnetic interference. A sharp transition band is critical for precise spectral shaping and…

We demonstrate experimentally an optical system for under-sampling several bandwidth limited signals with carrier frequencies that are not known apriori that can be located anywhere within a very broad frequency region between 0-18 GHz. The…

This paper presents 28 GHz and 73 GHz empirically-derived large-scale and small-scale channel model parameters that characterize average temporal and angular properties of multipaths. Omnidirectional azimuth scans at both the transmitter…

Millimeter wave (mmWave) communication links for 5G cellular technology require high beamforming gain to overcome channel impairments and achieve high throughput. While much work has focused on estimating mmWave channels and designing…

Fifth generation (5G) wireless systems are expected to combine emerging transmission technologies, such as large-scale multiple-input multiple-output (MIMO) and non-orthogonal multi-carrier waveforms, to improve the spectral efficiency and…

In this paper, taking the view that a linear parallel interference canceller (LPIC) can be seen as a linear matrix filter, we propose new linear matrix filters that can result in improved bit error performance compared to other LPICs in the…

Fifth generation (5G) wireless networks are expected to utilize wide bandwidths available at millimeter wave (mmWave) frequencies for enhancing system throughput. However, the unfavorable channel conditions of mmWave links, e.g., higher…

Polar codes have received growing attention in the past decade and have been selected as the coding scheme for the control channel in the fifth generation (5G) wireless communication systems. However, the conventional polar codes have only…

This paper describes the design, construction and testing of a dual-band monopole microstrip patch antenna to operate in the GSM and DCS bands. For compactness the monopole antenna is mounted on top of a FR4 substrate and is designed as a…

This article presents a fully 3D-printed wideband metasurface folded reflectarray antenna (MFRA) operating in the millimeter-wave n257 band. The proposed MFRA integrates a novel polarization-rotating reflective metasurface (RMS), a compact…