相关论文: Dependence of Adhesive Friction on Surface Roughne…
Cohesive granular materials such as wet sand, snow, and powders can flow like a viscous liquid. However, the elementary mechanisms of momentum transport in such athermal particulate fluids are elusive. As a result, existing models for…
Elastomeric materials when sliding on clean and rough surfaces generate wrinkles at the interface due to tangential stress gradients. These interfacial folds travel along the bottom of elastomer as surface detachment waves to facilitate the…
Sensitive and fast force measurements are performed on sheared granular layers undergoing stick-slip motion, along with simultaneous imaging. A full study has been done for spherical particles with a +-20% size distribution. Stick-slip…
We study in detail the recent suggestions by Tshiprut et al. [Phys. Rev. Lett. 95, 016101 (2005)] to tune tribological properties at the nanoscale by subjecting a substrate to periodic mechanical oscillations. We show that both in…
We study the dynamics of the solid to liquid transition for a model material made of elastic particles immersed in a viscous fluid. The interaction between particle surfaces includes their viscous lubrication, a sharp repulsion when they…
Sliding friction across a thin soft lubricant film typically occurs by stick-slip, the lubricant fully solidifying at stick, yielding and flowing at slip. The static friction force per unit area preceding slip is known from molecular…
The adhesion between dry solid surfaces is typically governed by contact forces, involving surface forces and elasticity. For surfaces immersed in a fluid, out-of-contact adhesion arises due to the viscous resistance to the opening of the…
From soap-covered dishes to freshly cleaned floors, surfactants can make surfaces slippery; yet, the underlying mechanism remains poorly understood. Here, we identify the molecular origin behind this ubiquitous phenomenon using macroscopic…
Contact mechanics-based models for the friction of nominally flat rough surfaces have not been able to adequately capture certain key experimentally observed phenomenona, such as the transition from a static friction peak to a lower level…
The rheological behavior of polymer melts is strongly influenced by parameters such as chain length, chain stiffness, and architecture. In particular, shear thinning, characterized by a power-law decrease in shear viscosity with increasing…
Droplets splash when they impact dry, flat substrates above a critical velocity that depends on parameters such as droplet size, viscosity and air pressure. By imaging ethanol drops impacting silicone gels of different stiffnesses we show…
We present Molecular Dynamics simulations of one- and two-dimensional bead-spring models sliding on incommensurate substrates. We investigate how sliding friction is affected by interaction anharmonicity and structural defects. In their…
Transition-metal dichalcogenides (TMDs) are commonly used as solid lubricants in various environments. Molybdenum disulfide is the most studied and applied TMD solid lubricant, but other members may have similar or even better sliding…
Modelling of rough frictional interfaces is often based on asperity models, in which the individual behaviour of individual microjunctions is assumed. In the absence of local measurements at the microjunction scale, quantitative comparison…
The morphology of an elastic strip subject to vertical compressive stress on a frictional rigid substrate is investigated by a combination of theory and experiment. We find a rich variety of morphologies, which -when the bending elasticity…
The shear rate dependence of the slip length in thin polymer films confined between atomically flat surfaces is investigated by molecular dynamics simulations. The polymer melt is described by the bead-spring model of linear flexible…
The response to a localized force provides a sensitive test for different models of stress transmission in granular solids. The elasto-plastic models traditionally used by engineers have been challenged by theoretical and experimental…
Recent studies have pointed out the importance of the basal friction on the dynamics of granular flows. We present experimental results on the influence of the roughness of the inclined plane on the dynamics of a monodisperse dry granular…
Elastic wave propagation provides a noninvasive way to probe granular materials. The discrete element method using particle configuration as input, allows a micromechanical interpretation on the acoustic response of a given granular system.…
Biomimetic scale-covered substrates provide geometric tailorability via scale orientation, spacing and also interfacial properties of contact in various deformation modes. No work has investigated the effect of friction in twisting…