相关论文: PAPR Reduction of FBMC Signals Based on Uniform an…
The OFDM waveform exhibits high fluctuation in the signal envelope which causes distortion in the nonlinear power amplifier of the transmitter. Peak-to-Average Power Ratio (PAPR) and Cubic Metric (CM) are the common metrics to quantify the…
This work establishes the design, analysis, and fine-tuning of a Peak-to-Average-Power-Ratio (PAPR) reducing system, based on compressed sensing at the receiver of a peak-reducing sparse clipper applied to an OFDM signal at the transmitter.…
This paper presents an innovative approach to mitigating the peak-to-average power ratio (PAPR). The proposed method uses a deep learning model called autoencoders (AEs) to simplify the process and avoid the complex calculations of…
Peak to average power ratio (PAPR) constrained power allocation in single carrier multiuser (MU) single-input multiple-output (SIMO) systems with iterative frequency domain (FD) soft cancelation (SC) minimum mean squared error (MMSE)…
This letter presents an improved peak cancellation (PC) scheme for peak-to-average power ratio (PAPR) reduction in orthogonal frequency division multiplexing (OFDM) systems. The main idea is based on a serial peak cancellation (SPC) mode…
High peak-to-average power ratio (PAPR) is a critical problem in orthogonal frequency-division multiplexing (OFDM). The fifth-generation New Radio (5G NR) facilitates the utilization of multiple heterogeneous bandwidth parts (BWPs), which…
In this paper, we propose two low-complexity peak to average power ratio(PAPR) reduction algorithms for orthogonal frequency division multiplexing(OFDM) signals. The main content is as follows: First, a non-convex optimization model is…
Orthogonal Frequency Division Multiplexing (OFDM) is an efficient method of data transmission for high speed communication systems. However, the main drawback of OFDM system is the high Peak to Average Power Ratio (PAPR) of the transmitted…
In this paper, we consider channel estimation problem in the uplink of filter bank multicarrier (FBMC) systems. We propose a pilot structure and a joint multiuser channel estimation method for FBMC. Opposed to the available solutions in the…
High peak-to-average power ratio (PAPR) is one of the main factors limiting cell coverage for cellular systems, especially in the uplink direction. Discrete Fourier transform spread orthogonal frequency-domain multiplexing (DFT-s-OFDM) with…
Filter bank multi-carrier (FBMC) offers superior spectral properties compared to cyclic-prefix orthogonal frequency-division multiplexing (CP-OFDM), at the cost of an inherent shortcoming in dispersive channels called intrinsic imaginary…
The orthogonal frequency division multiplexing is a very efficient modulation technique that can achieve very high throughput by transmitting many carriers simultaneously and it is spectrally efficient because of the proximity of the…
An OFDM system is combined with multiple-input multiple-output (MIMO) in order to increase the diversity gain and system capacity over the time variant frequency-selective channels. However, a major drawback of MIMO-OFDM system is that the…
High peak-to-average power ratio (PAPR) has long posed a challenge for multi-carrier systems, impacting amplifier efficiency and overall system performance. This paper introduces dynamic angle fractional Fourier division multiplexing…
Increasing demands on high data rate mobile communications services will inevitably drive future broadband mobile communication systems toward achieving data transmission rates in excess of 100 Mbps. One of the promising technologies which…
In this paper, we propose two low-complexity optimization methods to reduce peak-to-average power ratio (PAPR) values of orthogonal frequency division multiplexing (OFDM) signals via alternating direction method of multipliers (ADMM).…
In this letter, we propose a low complex data-null subcarrier switching-based peak-to-average power ratio (PAPR) reduction scheme for the orthogonal frequency division multiplexing (OFDM) systems, which provides improved bit error rate. We…
Vibration-based condition monitoring (VBCM) is widely utilized in various applications due to its non-destructive nature. Recent advancements in sensor technology, the Internet of Things (IoT), and computing have enabled the facilitation of…
Orthogonal Frequency Division Multiplexing (OFDM) is widely used in many digital communication systems due to its advantages such us high bit rate, strong immunity to multipath and high spectral efficiency but it suffers a high…
Orthogonal frequency division multiplexing (OFDM) is a promising modulation radio access scheme for next generation wireless communication systems because of its inherent immunity to multipath interference due to a low symbol rate, the use…