相关论文: Improvement in the performance of multilayer insul…
Multilayer insulation (MLI) is an important technique for the reduction of radiation heat load in cryostats. The present work is focused on investigation for the selection of suitable reflective layer and spacer material in MLI systems. In…
In the field of radiowave detection, enlarging the receiver aperture to enhance the amount of light detected is essential for greater scientific achievements. One challenge in using radio transmittable apertures is keeping the detectors…
We have developed a heat shield based on a metamaterial engineering approach to shield a region from transient diffusive heat flow. The shield is designed with a multilayered structure to prescribe the appropriate spatial profile for heat…
The paper analyzes the radiative thermal transfer in a liquid helium cryostat with liquid nitrogen shielding. A infinite plane walls model is used for demonstrating a method for lowering the radiative heat transfer and the numerical results…
The effects of insulating lids on the convection beneath were investigated experimentally using rectangular convection cells in the flux Rayleigh number range $2.3\times10^{9}\leq Ra_F \leq 1.8\times10^{11}$ and cylindrical cells in the…
Improving the heat transfer coefficient is crucial across various energy utilization processes for maintaining device safety and stability with high energy efficiency. However, in scenarios with limited heat capacity flow rates, increasing…
We report on optical design and applications of hybrid meso-scale devices and materials that combine optical and thermal management functionalities owing to their tailored resonant interaction with light in visible and infrared frequency…
Asymmetric heat transfer systems, often referred to as thermal diodes or thermal rectifiers, have garnered increasing interest due to their wide range of application possibilities. Most of those previous macroscopic thermal diodes either…
In this article, a general model for 1D thermal wave interference is derived for multi-layered coating systems on a thermally thick substrate using the same principles as for the well established one-layered and two-layered coating cases.…
A surface that selectively emits heat in the long-wave infrared (LWIR) can enable passive cooling in hot environments while retaining partial radiative insulation in cold conditions, but its real-world deployment is limited by reliance on…
In this work, a thermal energy transfer problem in a one-dimensional multilayer body is theoretically analyzed, considering diffusion, advection, internal heat generation or loss linearly dependent on temperature in each layer, as well as…
Features of thermal transport in multilayered porous silicon nanostructures are considered. Such nanostructures were fabricated by electrochemical etching of monocrystalline Si substrates by applying periodically changed current density.…
A new method of refrigeration is proposed. Cooling is obtained by thermionic emission of electrons over periodic barriers in a multilayer geometry. These could be either Schottky barriers between metals and semiconductors or else barriers…
One of the ways natural and synthetic systems regulate temperature is via circulating fluids through vasculatures embedded within their bodies. Because of the flexibility and availability of proven fabrication techniques, vascular-based…
Both the magnitude and spectrum of the blackbody-radiation distribution change with temperature. Here, we designed the temperature-dependent spectral emissivity of a coating to counteract all the changes in the blackbody-radiation…
One of the important stages in the creation of the scientific and technical foundations for the calculation, design and manufacturing technology of the lowest heat-conductivity thermal protection from screen-vacuum thermal insulation (SVTI)…
It is commonplace in helium cryogenic systems to utilize vacuum insulation to mitigate convective heat transfer to the low temperature fluids. While the insulating vacuum meaningfully improves cryogenic system thermal performance, failure…
In this paper thermal conductivity and thermal diffusivity of a two layer system is examined from the theoretical point of view. We use the one dimensional heat diffusion equation with the appropriate solution in each layer and boundary…
A standard quarter-wavelength multilayer optical coating will produce the highest reflectivity for a given number of coating layers, but in general it will not yield the lowest thermal noise for a prescribed reflectivity. Coatings with the…
The authors use two insulator layers in thermotunnel refrigerator to modify the shape of the tunneling barrier so that electrons with high kinetic energy pass it with increased probability. Theoretical analysis show that the overall…