相关论文: Mechanical Properties and Pore Size Distribution i…
We perform molecular dynamics simulations to characterize the occurrence of inhomogeneous shear flows in soft jammed materials. We use rough walls to impose a simple shear flow and study the athermal motion of jammed assemblies of soft…
The effect of a local shear transformation on plastic deformation of a three-dimensional amorphous solid is studied using molecular dynamics simulations. We consider a spherical inclusion, which is gradually transformed into an ellipsoid of…
The shear modulus G of two glass-forming colloidal model systems in d=3 and d=2 dimensions is investigated by means of, respectively, molecular dynamics and Monte Carlo simulations. Comparing ensembles where either the shear strain gamma or…
The behavior of shear-oscillated amorphous materials is studied using a coarse-grained model. Samples are prepared at different degrees of annealing and then subject to athermal and quasistatic oscillatory deformations at various fixed…
We investigate shear strength properties of wet granular materials in the pendular state (i.e. the state where the liquid phase is discontinuous) as a function of water content. Sand and glass beads were wetted and tested in a direct shear…
An experimental investigation is reported on the effect of shear on the bursting of molten ultra-thin polymer films embedded in an immiscible matrix. By using an optical microscope coupled with a shearing hotstage, the dewetting dynamics,…
We present results on a meso-scale model for amorphous matter in athermal, quasi-static (a-AQS), steady state shear flow. In particular, we perform a careful analysis of the scaling with the lateral system size, $L$, of: i) statistics of…
We introduce a coarse-grained model for atomic glass formers. Its elements are physically motivated local microscopic dynamical rules parameterized by observables. Results of the model are established and used to interpret the measured…
We study the two-dimensional (2D) shear flow of amorphous solids within variants of an elastoplastic model, paying particular attention to spatial correlations and time fluctuations of, e.g., local stresses. The model is based on the local…
A method of modelling the three-dimensional microstructure of random isotropic two-phase materials is proposed. The information required to implement the technique can be obtained from two-dimensional images of the microstructure. The…
``Shear softening" refers to the observed reduction in shear modulus when the stress on an amorphous solid is increased beyond the initial linear region. Careful numerical quasi-static simulations reveal an intimate relation between plastic…
During magma vesiculation, permeability is established when growing bubbles begin to form connected networks, which allow fluids to percolate. This percolation threshold controls the relative rates between magma ascent and volatile…
Thermo-responsive hydrogels are a promising material for creating controllable actuators for use in micro-scale devices, since they expand and contract significantly (absorbing or expelling fluid) in response to relatively small temperature…
Amorphous solids yield in strain-controlled protocols at a critical value of the strain. For larger strains the stress and energy display a generic complex serrated signal with elastic segments punctuated by sharp energy and stress plastic…
The dynamic collapse of pores under shock loading is thought to be directly related to hot spot generation and material failure, which is critical to the performance of porous energetic and structural materials. However, the shock…
The shear-transformation-zone (STZ) theory of plastic deformation in glass-forming materials is reformulated in light of recent progress in understanding the roles played the effective disorder temperature and entropy flow in nonequilibrium…
Pore space characteristics of biochars may vary depending on the used raw material and processing technology. Pore structure has significant effects on the water retention properties of biochar amended soils. In this work, several biochars…
Direct modeling of porous materials under shock is a complex issue. We investigate such a system via the newly developed material-point method. The effects of shock strength and porosity size are the main concerns. For the same porosity,…
Understanding the structural dynamics of many-particle glassy systems remains a key challenge in statistical physics. Over the last decade, glassy dynamics has also been reported in biological tissues, but is far from being understood. It…
We present the results of numerical simulations of an atomistic system undergoing plastic shear flow in the athermal, quasistatic limit. The system is shown to undergo cascades of local rearrangements, associated with quadrupolar energy…