相关论文: Magnetic Measurements at Warm of the First FCC-ee …

A single aperture Canted-Cosine-Theta (CCT) quadrupole magnet, made of NbTi superconductors, has been developed for the final focus region of the FCC-ee study. The conductor layout is optimised to mitigate edge effects on one of the two…

Iron-free CCT magnet design offers many advantages, one being the excellent field quality and the absence of multipole components. However, edge effects are present, although they tend to integrate out over the length of the magnet. Many…

A single-aperture, two-layer Canted-Cosine-Theta (CCT) sextupole magnet using high-temperature superconducting (HTS) ReBCO tape has been developed for the short straight sections (SSS) of FCC through the FCCee-HTS4 project. The magnet was…

The design of the region close to the interaction point of the FCC-ee experiments is especially challenging. The beams collide at an angle (+-15 mrad) in the high-field region of the detector solenoid. Moreover, the very low vertical…

A conduction-cooled superconducting magnet producing a transverse field of 4 Tesla has been designed for the new generation multi-field coupling measurement system, which was used to study the mechanical behavior of superconducting samples…

The CSR External-target Experiment (CEE) is a large-scale spectrometer under construction at the Heavy Ion Research Facility in Lanzhou (HIRFL) for studying the phase structure of nuclear matter at high baryon density and the equation of…

MQXC is a Nb-Ti quadrupole designed to meet the accelerator quality requirements needed for the phase-1 LHC upgrade, now superseded by the high luminosity upgrade foreseen in 2021. The 2-m-long model magnet was tested at room temperature…

A Faraday force magnetometer is presented for measurements of magnetization at temperatures down to 100~mK and in magnetic fields up to 14~T. The specimen is mounted on a flexible cantilever forming a force-sensing capacitor in combination…

We report on the design and performance of a highly sensitive combined $^3$He/Cs magnetometer for the absolute measurement of magnetic fields. The magnetometer relies on the magnetometric detection of the free spin precession of nuclear…

We investigate the contributions of finite-temperature magnetic fluctuations to the thermodynamic properties of bcc Fe as a function of pressure. First, we apply a tight-binding total-energy model parameterized to first-principles…

A 325 MHz aluminum prototype of a spatially periodic rf quadrupole focusing linac was developed at the Institute of Modern Physics, Chinese Academy of Sciences, as a promising candidate for the front end of a high-current linac. It consists…

High cooling power of magnetocaloric refrigeration can be achieved only at large amounts of heat, which can be transferred in one cycle from cold end to hot end at quasi-isothermal conditions. The simple experimental method for direct…

Quadrupole electromagnets have been developed with a hollow coil produced using an improved periodic reverse electroforming. These will be installed in each of the drift tubes of the DTL (324 MHz) as part of the JAERI/KEK Joint Project at…

MDPCT1 is a four-layer cos-theta Nb3Sn dipole demonstrator developed and tested at FNAL in the framework of the U.S. Magnet Development Program. The magnet reached record fields for accelerator magnets of 14.1 T at 4.5 K in the first test…

This paper describes a new design of superconducting dipole magnet prototype by the use of tilted solenoids. The magnet prototype, which consists of four layers of superimposed tilted solenoids with operating current of 3708 A, will produce…

This study shows the development and performance assessment of a novel set-up that enables the research of structural materials for fusion reactors, by making possible simultaneous application of temperature (up to 450$^{\circ}$C) and…

Theoretical studies of magnets have traditionally concentrated on either classical spins, or the extreme quantum limit of spin-1/2. However, magnets built of spin-1 moments are also intrinsically interesting, not least because they can…

A numerical model of single-domain nanoscale iron magnets fabricated using scanning-microscope-assisted chemical vapor deposition is simulated using finite-temperature micromagnetics. A Projective-dynamics method is used to determine the…

MQXFA production series quadrupole magnets are being built for the Hi-Lumi (HL) LHC upgrade by the US Accelerator Upgrade Project (US-HL-LHC AUP). These magnets are being placed in pairs, as a cold mass, within cryostats at Fermilab, and…

Several coil structures have been used in accelerator superconducting quadrupole magnets, and cos2{\theta} quadrupole magnets are the most mature in theoretical research and engineering applications. However, the cos2{\theta} quadrupole…