相关论文: Cognitive-Driven Optimization of Sparse Array Tran…

In this work, we propose a novel strategy of adaptive sparse array beamformer design, referred to as regularized complementary antenna switching (RCAS), to swiftly adapt both array configuration and excitation weights in accordance to the…

A receiver with perfect channel state information (CSI) in a point-to-point multiple-input multiple-output (MIMO) channel can compute the transmit beamforming vector that maximizes the transmission rate. For frequency-division duplex, a…

As radio-frequency (RF) antenna, component and processing capabilities increase, the ability to perform multiple RF system functions from a common aperture is being realized. Conducting both radar and communications from the same system is…

An efficient beamforming design is proposed for continuous aperture array (CAPA)-based point-to-point multiple-input multiple-output (MIMO) systems. In contrast to conventional spatially discrete array (SPDA)-MIMO systems, whose optimal…

Rydberg atomic quantum receivers have been seen as novel radio frequency measurements and the high sensitivity to a large range of frequencies makes it attractive for communications reception. However, current implementations of Rydberg…

A practical and scalable multicast beamformer design in multi-input multi-output~(MIMO) coded caching~(CC) systems is introduced in this paper. The proposed approach allows multicast transmission to multiple groups with partially…

Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…

This paper addresses the optimization challenges in dual-functional radar-communication (DFRC) systems with a focus on array selection and beamforming in dynamic and heterogeneous operational contexts. We propose a novel array selection…

Motivated by automotive applications, we consider joint radar sensing and data communication for a system operating at millimeter wave (mmWave) frequency bands, where a Base Station (BS) is equipped with a co-located radar receiver and…

Cognitive Radar Networks, which were popularized by Simon Haykin in 2006, have been proposed to address limitations with legacy radar installations. These limitations include large physical size, power consumption, fixed operating…

Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…

Intelligent reflecting surface (IRS) technology has recently attracted a significant interest in non-light-of-sight radar remote sensing. Prior works have largely focused on designing single IRS beamformers for this problem. For the first…

Channel estimation and data transmission constitute the most fundamental functional modules of multiple-input multiple-output (MIMO) communication systems. The underlying key tasks corresponding to these modules are training sequence…

This paper proposes compressed domain signal processing (CSP) multiple input multiple output (MIMO) radar, a MIMO radar approach that achieves substantial sample complexity reduction by exploiting the idea of CSP. CSP MIMO radar involves…

The joint detection and tracking of a moving target embedded in an unknown disturbance represents a key feature that motivates the development of the cognitive radar paradigm. Building upon recent advancements in robust target detection…

This paper considers joint beamformer design towards maximizing the mutual information in a coherent wireless sensor network with noisy observation and multiple antennae. Leveraging the weighted minimum mean square error and block…

The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…

A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…

As communication systems that employ millimeter wave (mmWave) frequency bands must use large antenna arrays to overcome the severe propagation loss of mmWave signals, hybrid beamforming has been considered as an integral component of mmWave…

In this paper, linear transceiver design for multi-hop amplify-and-forward (AF) multiple-input multiple-out (MIMO) relaying systems with Gaussian distributed channel estimation errors is investigated. Commonly used transceiver design…