相关论文: Dynamic Oversampling Tecniques for 1-Bit ADCs in L…

With the advent of the 5G wireless networks, achieving tens of gigabits per second throughputs and low, milliseconds, latency has become a reality. This level of performance will fuel numerous real-time applications, such as autonomy and…

Quantizers play a critical role in digital signal processing systems. Recent works have shown that the performance of quantization systems acquiring multiple analog signals using scalar analog-to-digital converters (ADCs) can be…

In general, real world signals are analog in nature. To capture these signals for further processing, or transmission, signals are converted into digital bits using analog-to-digital converter (ADC). In this conversion, a good amount of…

Millimeter wave (mmWave) massive MIMO can achieve orders of magnitude increase in spectral and energy efficiency, and it usually exploits the hybrid analog and digital precoding to overcome the serious signal attenuation induced by mmWave…

Digital beamforming and waveform generation techniques in MIMO radar offer enormous advantages in terms of flexibility and performance compared to conventional radar systems based on analog implementations. To allow for such fully digital…

This study proposes the construction of a transmit signal for large-scale antenna systems with cost-effective 1-bit digital-to-analog converters in the downlink. Under quadrature-amplitude-modulation constellations, it is still an open…

We investigate full-duplex (FD) multi-user multiple input single-output systems with coarse quantization, aiming to characterize the impact of employing low-resolution analog-to-digital converters (ADCs) on self-interference (SI) and to…

We study the spectral efficiency (SE) of a mixed-ADC massive MIMO system in which K single-antenna users communicate with a base station (BS) equipped with M antennas connected to N high-resolution ADCs and M-N one-bit ADCs. This…

Antenna selection in Massive MIMO (Multiple Input Multiple Output) communication systems enables reduction of complexity, cost and power while keeping the channel capacity high and retaining the diversity, interference reduction, spatial…

We consider timing and frequency synchronization for the massive multiuser (MU) multiple-input multiple-output (MIMO) downlink where 1-bit digital-to-analog converters (DACs) are used at the base station (BS). We focus on the practically…

This paper focuses on channel estimation for mmWave MIMO systems with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). The channel estimation performance with 1-bit spatial sigma-delta ADCs depends on the quantization noise…

The one-bit spatial Sigma-Delta concept has recently been proposed as an approach for achieving low distortion and low power consumption for massive multi-input multi-output systems. The approach exploits users located in known angular…

We consider channel estimation for an uplink massive multiple-input multiple-output (MIMO) system where the base station (BS) uses an array with low-resolution (1-2 bit) analog-to-digital converters and a spatial Sigma-Delta…

Millimeter wave (mmWave) spectrum has drawn attention due to its tremendous available bandwidth. The high propagation losses in the mmWave bands necessitate beamforming with a large number of antennas. Traditionally each antenna is paired…

The aim of this paper is to investigate the recently developed mixed-ADC architecture for frequency-selective channels. Multi-carrier techniques such as orthogonal frequency division multiplexing (OFDM) are employed to handle inter-symbol…

We propose a novel linear minimum-mean-squared-error (MMSE) precoder design for a downlink (DL) massive multiple-input-multiple-output (MIMO) scenario. For economical and computational efficiency reasons low resolution 1-bit…

Massive MIMO is a variant of multiuser MIMO, where the number of antennas $M$ at the base-station is large, and generally much larger than the number of spatially multiplexed data streams to/from the users. It has been observed that in many…

Dynamic metasurface antennas (DMAs) beamform through low-powered components that enable reconfiguration of each radiating element. Previous research on a single-user multiple-input-single-output (MISO) system with a dynamic metasurface…

Millimeter wave (mmWave) multi-user massive multi-input multi-output (MIMO) is a promising technique for the next generation communication systems. However, the hardware cost and power consumption grow significantly as the number of radio…

In this paper, we investigate the relationship between the dynamic range and quantization noise power in modulo analog-to-digital converters (ADCs). Two modulo ADC systems are considered: (1) a modulo ADC which outputs the folded samples…