相关论文: Electromagnetic Radiation Detection with Broad Spe…
Photoacoustic detection is a sensitive method for measurement of light-absorbing particles directly in the aerosol phase. In this article, we demonstrate a new sensitive technique for photoacoustic aerosol absorption measurements using a…
Optical power measurements are needed in practically all technologies based on light. Here we report a general-purpose optical power detector based on the photoacoustic effect. Optical power incident on the detector's black absorber…
We present a mechanical cantilever-based tabletop interferometer to measure the radiation force exerted by light. Using a high-power (~ 1W) pulsed laser beam, we excite mechanical oscillations in a thin metallic cantilever. The cantilever…
In optical detection setups to measure the deflection of micro-cantilevers, part of the sensing light is absorbed, heating the mechanical probe. We present experimental evidences of a frequency shift of the resonant modes of a cantilever…
A force measurement technique has been developed that utilizes a clamped fiber optic element both as a cantilever and as a highly sensitive probe of the static and dynamic displacement of a sample that is mounted near its free end. Light…
Atomic Force Microscopy (AFM) methods utilizing resonant mechanical vibrations of cantilevers in contact with a sample surface have shown sensitivities as high as few picometers for detecting surface displacements. Such a high sensitivity…
An experimental study of the parameters of electromagnetic and X-ray radiation was carried out on a small-sized direct-acting electron accelerator with inductive storage and a plasma opening switch. Frequency spectra have been determined,…
This letter proposes a new method based on ultrafast high energy electron radiography to diagnose transient electromagnetic field. For the traditional methods, large scattering from matter will increase the uncertainty of measurement, but…
Optical detection back-action in cantilever resonant or static detection presents a challenge when striving for state-of-the-art performance. The origin and possible routes for minimizing optical back-action have received little attention…
An all-optical detection method for the detection of acoustic pressure waves is demonstrated. The detection system is based on a stripped (bare) single-mode fiber. The fiber vibrates as a standard cantilever and the optical output from the…
High-frequency atomic force microscopy has enabled extraordinary new science through large bandwidth, high speed measurements of atomic and molecular structures. However, traditional optical detection schemes restrict the dimensions, and…
We present the design and implementation of a scanning probe microscope, which combines electrically detected magnetic resonance (EDMR) and (photo-)conductive atomic force microscopy ((p)cAFM). The integration of a 3-loop 2-gap X-band…
We describe our research programme on the use of atomic magnetometers to detect conductive objects via electromagnetic induction. The extreme sensitivity of atomic magnetometers at low frequencies, up to seven orders of magnitude higher…
Quantum enhanced sensing is a powerful technique in which nonclassical states are used to improve the sensitivity of a measurement. For enhanced mechanical displacement sensing, squeezed states of light have been shown to reduce the photon…
Measurements of the deflection induced by thermal noise have been performed on a rectangular atomic force microscope cantilever in air. The detection method, based on polarization interferometry, can achieve a resolution of 1E-14 m/rtHz in…
We present a method of broadening the dynamic range of optical interferometric detection of cantilever displacement. The key idea of this system is to use a wavelength-tunable laser source. The wavelength is subject to proportional-integral…
We report a simple demonstration of radiation pressure on a table-top experiment. Utilizing dynamic force microscopy in ambient environment, the resonant motion of a cm-sized cantilever driven by an amplitude-modulated diode laser is…
This paper describes a radiation pressure meter based on a diamagnetic spring. We take advantage of the diamagnetic property of pyrolytic carbon to make an elementary levitated system. It is equivalent to a torsional spring-mass-damper…
In this work we introduce a new method of a ferromagnetic resonance (FMR) detection from thin, nm-size, films. Our setup is based on the commercial piezo-cantilever, used for atomic force microscopy. It has an option to rotate the sample in…
We consider a far infrared (terahertz), room-temperature detector based on a microcantilever sensor of the radiation pressure. This system has a significantly higher sensitivity than existing uncooled detectors in the far infrared…