相关论文: Class-B cable-driving SQUID amplifier

We suggest SQUID amplifier configuration intended for millikelvin refrigerators where cooling power is limited and hence high power efficiency is desirable. The configuration operates the SQUIDs in class-AB rather than the traditional…

We have designed and fabricated an integrated two-stage SQUID amplifier, requiring only one bias line and one flux setpoint line. From the biasing viewpoint the two stages are connected in series while from the signal propagation viewpoint…

Frequency Domain Multiplexed detector arrays constructed of superconducting Transition Edge Sensors in the current-summing configuration suffer from the finite impedance of the summing node which should ideally be zero. We suggest two…

We demonstrate a highly linear superconducting quantum interference device (SQUID) amplifier based on a double-loop (Bi-SQUID) architecture incorporating three superconductor-normal metal-superconductor (S-N-S) junctions. Fabricated using…

Due to their superior noise performance, SQUIDs are an attractive alternative to high electron mobility transistors for constructing ultra-low-noise microwave amplifiers for cryogenic use. We describe the use of a lumped element SQUID…

We present measurements of an amplifier operating at 3.8 GHz with 150 MHz of bandwidth based on the microstrip input-coil resonance of a dc superconducting quantum interference device (SQUID) with submicron Josephson junctions. The noise…

SQUID arrays are promising candidates for low profile antennas and low noise amplifier applications. We present the integrated circuit designs and results of DC and RF measurements of the wideband serial arrays based on integration of…

We report on the total noise from an inductive motion transducer for a gravitational-wave antenna. The transducer uses a two-stage SQUID amplifier and has a noise temperature of 1.1 mK, of which 0.70 mK is due to back-action noise from the…

Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit…

We develop a two-dimensional (2D) Superconducting Quantum Interference Filter (SQIF) array based on recently introduced high-linearity tri-junction bi-SQUIDs. Our bi-SQUID SQIF array design is based on a tight integration of individual bi-…

Direct-current superconducting quantum interference devices (dc-SQUIDs) are one of the most sensitive magnetic detectors. These sensors are extensively used in the readout of superconducting transition edge sensors (TESs), which are used…

We have implemented a resonant circuit that uses a SQUID as a flux-sensitive Josephson inductor for qubit readout. In contrast to the conventional switching current measurement that generates undesired quasi-particles when the SQUID…

Designing superconducting electronic devices involves a careful study of all the elements in the circuit, including the superconducting bias leads, however, the effect of the bias current leads on the performance of the device have not been…

To better understand the working principles of Superconducting Quantum Interference Device (SQUID) direct readout schemes, which work in different bias and amplifier modes with different internal feedback schemes, we present the complete…

The current-voltage characteristics of Superconducting Quantum Interference Devices (SQUIDs) are known to modulate as a function of applied magnetic field with a period of one flux quantum $\Phi_0=h$/2e. Here we report on the fabrication…

We suggest using a device called the Bootstrap Superconducting Quantum Interference Device (BS-SQUID) to break the reciprocity in charge transport. This device uses magnetic flux back-action to create a nonreciprocal current-voltage…

A flux qubit readout scheme involving a dispersive technique coupled to a microstrip squid amplifier has been tested experimentally. Thanks to the almost quantum limited noise of this amplifier at low temperature, this readout device is…

We propose a way for realizing a two-qubit controlled phase gate with superconducting quantum interference devices (SQUIDs) coupled to a superconducting resonator. In this proposal, the two lowest levels of each SQUID serve as the logical…

We describe a circuit model for a flux-driven SQUID. This is useful for developing insight into how these devices perform as active elements in parametric amplifiers. The key concept is that frequency mixing in a flux-pumped SQUID allows…

Pulsed readout of Direct Current (DC) SUperconducting Quantum Interference Device (SQUID) is crucial for experiments which need to be performed at millikelvin temperatures, such as the readout of superconducting and electron spin based…