相关论文: Beamspace Precoding and Beam Selection for Wideban…

MIMO systems are considered as most promising for wireless communications. However, with an increasing number of radio front ends the corresponding energy consumption and costs become an issue, which can be relieved by the utilization of…

Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems typically employ hybrid mixed signal processing to avoid expensive hardware and high training overheads. {However, the lack of fully digital beamforming at…

Mobility and blockage are two critical challenges in wireless transmission over millimeter-wave (mmWave) and Terahertz (THz) bands. In this paper, we investigate network massive multiple-input multiple-output (MIMO) transmission for…

This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…

The two-stage precoding has been proposed to reduce the overhead of both the channel training and the channel state information (CSI) feedback for the massive multiple-input multiple-output (MIMO) system. But the overlap of the…

Accurate channel parameter estimation is challenging for wideband millimeter-wave (mmWave) large-scale hybrid arrays, due to beam squint and much fewer radio frequency (RF) chains than antennas. This paper presents a novel joint delay and…

Low overhead channel estimation based on compressive sensing (CS) has been widely investigated for hybrid wideband millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. The channel sparsifying dictionaries used in prior…

In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…

Efficient resource allocation with hybrid precoder design is essential for massive MIMO systems operating in millimeter wave (mmW) domain. Owing to a higher energy efficiency and a lower complexity of a partially connected hybrid…

Scaling the number of antennas up is a key characteristic of current and future wireless communication systems. The hardware cost and power consumption, however, motivate large-scale MIMO systems, especially at millimeter wave (mmWave)…

In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…

This paper is concerned with the channel estimation problem in millimetre wave (MMW) wireless systems with large antenna arrays. By exploiting the sparse nature of the MMW channel, we present an efficient estimation algorithm based on a…

Generalized spatial modulation (GenSM) aided millimeter wave (mmWave) multiple-input multiple-output (MIMO) has recently received substantial academic attention. However, due to the insufficient exploitation of the transmitter's knowledge…

Cell-free massive MIMO systems consist of many distributed access points with simple components that jointly serve the users. In millimeter wave bands, only a limited set of predetermined beams can be supported. In a network that…

Millimeter wave (mmWave) is a key technology for fifth-generation (5G) and beyond communications. Hybrid beamforming has been proposed for large-scale antenna systems in mmWave communications. Existing hybrid beamforming designs based on…

In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…

Configuring the hybrid precoders and combiners in a millimeter wave (mmWave) multiuser (MU) multiple-input multiple-output (MIMO) system is challenging in frequency selective channels. In this paper, we develop a system that uses…

The potential of using millimeter-wave (mmWave) to encounter the current bandwidth shortage has motivated packing more antenna elements in the same physical size which permits the advent of massive multiple-input-multiple-output (MIMO) for…

Recently, a technique called beam-space MIMO has been demonstrated as an effective approach for transmitting multiple signals while using a single RF-chain. In this work, we present novel design considerations and a compact antenna solution…

Due to the short wavelength and large attenuation of millimeter-wave (mmWave), mmWave BSs are densely distributed and require beamforming with high directivity. When the user moves out of the coverage of the current BS or is severely…