相关论文: A new Topology of a High-Voltage-Gain DC-DC Conver…
In this work, we investigate grid-forming (GFM) control for dc/ac power converters in emerging power systems that contain ac and dc networks, renewable generation, and conventional generation. We propose a novel power-balancing GFM control…
A novel topology for a high gain two-stage amplifier is proposed. The proposed circuit is designed in a way that the non-dominant pole is at output of the first stage. A positive capacitive feedback (PCF) around the second stage introduces…
In this paper, a full-bridge boost power converter topology is studied for power factor control, using output high order sliding mode control. The AC/DC converters are used for charging the battery and super-capacitor in hybrid electric…
Phase-shifted carrier pulse-width modulation (PSC-PWM) is a widely adopted scheduling algorithm in cascaded bridge converters, modular multilevel converters, and reconfigurable batteries. However, non-uniformed pulse widths for the modules…
The way in which electric power depends on the topology of circuits with mixed voltage and current sources is examined. The power flowing in any steady-state DC circuit is shown to depend on a minimal set of key variables called fundamental…
Transimpedance amplifiers (TIAs) are essential in sensor electronics, converting input currents into output voltages. Conventional TIAs utilize fixed-gain resistors, which saturate under high input currents and consequently result in…
This paper describes a SIMO DC-DC converter capable of generating all the required voltages (buck and boost) utilizing n-type transistors for the output switches. The design incorporates only one shared bootstrap capacitor and a single pad…
The grid-forming converter is an important unit in the future power system with more inverter-interfaced generators. However, improving its performance is still a key challenge. This paper proposes a generalized architecture of the…
Autonomous droop control PV inverters have improved voltage regulation compared to the inverters without grid support functions, but more flexible control techniques will be required as the number of solar photovoltaic (PV) installations…
The operating conditions of the power system have become more complex and changeable. This paper proposes a probabilistic load flow based on the cumulant method (PLF-CM) for the voltage sourced converter high voltage direct current…
In this work, a non-linear controller designed using non-linear transformation linearization and feedback is proposed for an inverter connected to a weak grid through a single-stage inductive filter. The proposed strategy is…
This paper proposes a programmable multi-input buck-boost structure method, which can enhance the operation tolerance for the PV array under extremely harsh climatic conditions. The proposed structure based on a traditional two switches…
Micro-inverter technologies are becoming increasingly popular as a choice of grid connection for small-scale photovoltaic systems. Efficiently harvesting the maximum energy from a photovoltaic system reduces the Levelized cost for solar…
Switched-Capacitor Converters (SCC) suffer from a fundamental power loss deficiency which make their use in some applications prohibitive. The power loss is due to the inherent energy dissipation when SCC operate between or outside their…
This paper presents a dissipativity-based distributed droop-free control and communication topology co-design framework for voltage regulation and current sharing in DC microgrids (MGs), where constant-power loads (CPLs) and voltage-source…
This paper presents current control method for a grid-connected partial resonant soft switching inverter. This inverter does not use an electrolytic capacitor and is capable of boosting and bucking the voltage. Grid-connected inverters are…
Wind power integration is an essential problem for modern power industry. In this paper, we develop a novel bilevel mixed integer optimization model to investigate wind power generation planning problem in an electricity market environment…
For enhancing power flow control in power transmission, a simplified new structure of direct power flow controller with continuous full regulation range (F-DPFC) was proposed. It has only one-stage power conversion and comprises of a…
We consider the problem of grid-forming control of power converters in low-inertia power systems. Starting from an average-switch three-phase inverter model, we draw parallels to a synchronous machine (SM) model and propose a novel…
Learning from two-level voltage source converters, the existing impedance-based stability analyses of modular multilevel converters (MMCs) primarily focus on system modes with finite closed-loop transfer functions, which consider…