相关论文: Focal-ratio-degradation (FRD) mitigation in a mult…

Here we present a laboratory analysis of the use of a 19-core photonic lantern (PL) in combination with neural network (NN) algorithms as an efficient focal plane wavefront sensor (FP-WFS) for adaptive optics (AO), measuring wavefront…

In the domain of disordered photonics, the characterization of optically opaque materials for light manipulation and imaging is a primary aim. Among various complex devices, multi-mode optical fibers stand out as cost-effective and…

We experimentally compare the optical bandwidth of a conventional single-mode fiber (SMF) with 3 different photonic crystal fibers (PCF) all optimized for visible applications. The spectral attenuation, single-turn bend loss, and mode-field…

The burgeoning field of astrophotonics explores the interface between astronomy and photonics. Important applications include photonic OH suppression at near-infrared wavelengths, and integrated photonic spectroscopy. These new photonic…

Optical interconnect is a potential solution to attain the large bandwidth on-chip communications needed in high performance computers in a low power and low cost manner. Mode-division multiplexing (MDM) is an emerging technology that…

We propose a focal-plane wavefront sensor (FPWFS) based on a short multimode fiber (MMF) capable of operating under moderately broadband illumination. By coupling the aberrated focal-plane field into an MMF of length <1 cm, we preserve…

A standard multimode optical fiber can be used as a general purpose spectrometer after calibrating the wavelength dependent speckle patterns produced by interference between the guided modes of the fiber. A transmission matrix was used to…

Mode division multiplexing (MDM) in optical fibers enables multichannel capabilities for various applications, including data transmission, quantum networks, imaging, and sensing. However, MDM optical fiber systems, usually necessities…

Federated fine-tuning (FedFT) has been proposed to fine-tune the pre-trained language models in a distributed manner. However, there are two critical challenges for efficient FedFT in practical applications, i.e., resource constraints and…

Several multi-core fibers (MCF) were characterized using Correlation Optical Time Domain Reflectometry (C-OTDR) in terms of propagation delay and polarization mode dispersion (PMD). The results show that the propagation delay in the cores…

We report on a method to obtain confocal imaging through multimode fibers using optical correlation. First, we measure the fiber's transmission matrix in a calibration step. This allows us to create focused spots at one end of the fiber by…

Multimode fibers (MMFs) can transmit multiple guided modes simultaneously, making them a promising platform for high-resolution biomedical imaging, endoscopy and high-bandwidth optical communication. However, their complex modal behavior,…

Photonic lanterns are made by adiabatically merging several single-mode cores into one multimode core. They provide low-loss interfaces between single-mode and multimode systems where the precise optical mapping between cores and individual…

We consider large-mode area photonic crystal fibers for visible applications where micro-deformation induced attenuation becomes a potential problem when the effective area A_eff is sufficiently large compared to lambda^2. We argue how a…

We demonstrate a new approach to classical fiber-fed spectroscopy. Our method is to use a photonic lantern that converts an arbitrary (e.g. incoherent) input beam into N diffraction-limited outputs. For the highest throughput, the number of…

A new approach to distributed cooperative beamforming in relay networks with frequency selective fading is proposed. It is assumed that all the relay nodes are equipped with finite impulse response (FIR) filters and use a filter-and-forward…

We propose and demonstrate two methods for modal decomposition in multi-mode fibres. Linearly polarized modes propagating in a slightly multi-mode fibre are easily retrieved from intensity measurements at the fibre output surface. The first…

We demonstrate a remote microwave/radio-frequency (RF) transfer technique based on the stabilization of a fiber link using a fiber-loop optical-microwave phase detector (FLOM-PD). This method compensates for the excess phase fluctuations…

In this paper, to accurately characterize the low inter-mode coupling of the weakly-coupled few mode fibers (FMFs), we propose a modified inter-mode coupling characterization method based on swept-wavelength interferometry measurement, in…

Multimode fibres offer the advantages of high resolution and miniaturization over single mode fibers in the field of optical imaging. However, multimode fibre's imaging is susceptible to perturbations of MMF that can lead to secondary…