相关论文: All-fiber frequency comb at 2 {\mu}m providing 1.4…

We present a 2-\mum frequency comb based on a reliable mode-locked Er:fiber laser with 100 MHz repetition rate. After shifting the spectrum of the amplified Er:fiber comb to longer wavelengths, a single-clad Tm/Ho:fiber is used as a…

Single-cycle pulses with deterministic carrier-envelope phase enable the study and control of light-matter interactions at the sub-cycle timescale, as well as the efficient generation of low-noise multi-octave frequency combs. However,…

We report the amplification of an all-normal dispersion supercontinuum pulse in a Thulium / Holmium co-doped all-fiber chirped pulse amplification system. With a -20 dB bandwidth of more than 300 nm in the range 1800-2100 nm the system…

Frequency combs with mode spacing in the range of 10 to 20 gigahertz (GHz) are critical for increasingly important applications such as astronomical spectrograph calibration, high-speed dual-comb spectroscopy, and low-noise microwave…

A compact and robust coherent laser light source that provides spectral coverage from the ultraviolet to infrared is desirable for numerous applications, including heterodyne super resolution imaging[1], broadband infrared microscopy[2],…

We present a laser frequency comb based upon a 250 MHz mode-locked erbium-doped fiber laser that spans more than 300 terahertz of bandwidth, from 660 nm to 2000 nm. The system generates 1.2 nJ, 70 fs pulses at 1050 nm by amplifying the 1580…

Mid-infrared frequency comb spectroscopy enables measurement of molecular at megahertz spectral resolution, sub-hertz frequency accuracy and microsecond acquisition speed. However, the widespread adoption of this technique has been hindered…

We propose and demonstrate a simple route to few-optical-cycle pulse generation from a mid-infrared fiber laser through nonlinear compression of pulses from a holmium-doped fiber oscillator using a short length of chalcogenide fiber and a…

We report on a high-power mid-infrared frequency comb source based on a femtosecond Er:fiber oscillator with a stabilized repetition rate at 250 MHz. The mid-infrared frequency comb is produced through difference frequency generation in a…

We report on the development of a high-power mid-infrared frequency comb with 100 MHz repetition rate and 100 fs pulse duration. Difference frequency generation is realized between two branches derived from an Er:fiber comb, amplified…

Over the past years, ultrafast lasers with average powers in the 100 W range have become a mature technology, with a multitude of applications in science and technology. Nonlinear temporal compression of these lasers to few- or even…

We investigate the generation of optical frequency combs through a cascade of four-wave mixing processes in nonlinear fibres with optimised parameters. The initial optical field consists of two continuous-wave lasers with frequency…

In this letter, we report on all-optical fiber approach to the generation of ultra-low noise microwave signals. We make use of two erbium fiber mode-locked lasers phase locked to a common ultra-stable laser source to generate an 11.55 GHz…

We demonstrate a compact watt-level all polarization-maintaining (PM) femtosecond fiber laser source at 1100 nm. The fiber laser source is seeded by an all PM fiber mode-locked laser employing a nonlinear amplifying loop mirror. The seed…

We report what we believe to be the lowest phase noise optical-to-microwave frequency division using fiber-based femtosecond optical frequency combs: a residual phase noise of -120dBc/Hz at 1 Hz offset from a 11.55GHz carrier frequency. We…

Reducing the pulse repetition rate of an optical frequency comb increases the pulse energy for a given average power. This enhances the efficiency of nonlinear frequency conversion and it facilitates extending the accessible wavelength…

Beginning with a continuous wave laser at 1064 nm, we generate a 30 GHz electro-optic frequency comb which contains 100 lines spanning 3 THz. The initial comb is subsequently amplified, spectrally broadened in normal dispersion photonic…

We present a hybrid fiber/waveguide design for a 100-MHz frequency comb that is fully self-referenced and temperature controlled with less than 5 W of electrical power. Self-referencing is achieved by supercontinuum generation in a silicon…

We demonstrate an optical frequency comb based on an erbium-doped-fiber femtosecond laser with the nonlinear polarization evolution scheme. The repetition rate of the laser is about 209 MHz. By controlling an intra-cavity electro-optic…

We generate a 200-nm optical frequency comb at 1.5 microns by injecting two single-frequency lasers into a highly nonlinear fiber, and explore its spectral phase properties and high power to demonstrate full nonlinear conversion into its…