相关论文: An analysis and visualization of the output mode-m…
Achieving the quantum noise targets of third-generation detectors will require 10 dB of squeezed-light enhancement as well as megawatt laser power in the interferometer arms - both of which require unprecedented control of the internal…
We demonstrate the potential of new adaptive optical technology to expand the detection horizon of gravitational-wave observatories. Achieving greater quantum-noise-limited sensitivity to spacetime strain hinges on achieving higher…
The ongoing global effort to detect gravitational waves continues to push the limits of precision measurement while aiming to provide a new tool for understanding both astrophysics and fundamental physics. Squeezed states of light offer a…
The Advanced LIGO gravitational wave detectors are nearing their design sensitivity and should begin taking meaningful astrophysical data in the fall of 2015. These resonant optical interferometers will have unprecedented sensitivity to the…
We study frequency dependent (FD) input-output schemes for signal-recycling interferometers, the baseline design of Advanced LIGO and the current configuration of GEO 600. Complementary to a recent proposal by Harms et al. to use FD input…
Isolating ground-based interferometric gravitational wave observatories from environmental disturbances is one of the great challenges of the advanced detector era. In order to directly observe gravitational waves, the detector components…
Nearly a century after Einstein first predicted the existence of gravitational waves, a global network of earth-based gravitational wave observatories is seeking to directly detect this faint radiation using precision laser interferometry.…
The first detection of gravitational waves by the Laser Interferometer Gravitational-wave Observatory (LIGO) in 2015 launched the era of gravitational wave astronomy. The quest for gravitational wave signals from objects that are fainter or…
Strongly squeezed states of light are a key technology in boosting the sensitivity of interferometric setups, such as in gravitational-wave detectors. However, the practical use of squeezed states is limited by optical loss, which reduces…
The Advanced LIGO gravitational wave detectors are second generation instruments designed and built for the two LIGO observatories in Hanford, WA and Livingston, LA. The two instruments are identical in design, and are specialized versions…
With the LIGO announcement of the first direct detection of gravitational waves (GWs), the GW Astronomy was formally ushered into our age. After one-hundred years of theoretical investigation and fifty years of experimental endeavor, this…
In the coming years, the gravitational wave community will be optimizing detector performance for a variety of astrophysical sources that make competing demands on the detector sensitivity in different frequency bands. In this paper we…
Sensitivity of future laser interferometric gravitational-wave detectors can be improved using squeezed light with frequency-dependent squeeze angle and/or amplitude, which can be created using additional so-called filter cavities. Here we…
The detectors of the laser interferometer gravitational-wave observatory (LIGO) are broadly limited by the quantum noise and rely on the injection of squeezed states of light to achieve their full sensitivity. Squeezing improvement is…
Detections of gravitational waves (GW) in the frequency band 35 Hz to 500 Hz have led to the birth of GW astronomy. Expected signals above 500 Hz, such as the quasinormal modes of lower mass black holes and neutron star mergers signatures…
In a recent table-top experiment we demonstrated the compatibility of three advanced interferometer techniques for gravitational wave detection, namely power-recycling, detuned signal-recycling and squeezed field injection. The…
The effect of gravitational waves (GWs) has been observed indirectly, by monitoring the change in the orbital frequency of neutron stars in a binary system as they lose energy via gravitational radiation. However, GWs have not yet been…
The raw outputs of the detectors within the Advanced Laser Interferometer Gravitational-Wave Observatory need to be calibrated in order to produce the estimate of the dimensionless strain used for astrophysical analyses. The two detectors…
Extending the sensitivity of terrestrial gravitational-wave detectors below 20 Hz is a long-standing challenge, limited by ground motion and inertial sensing noise. In this letter, we demonstrate ultra-high-vacuum compatible inertial…
The expansion and upgrade of the global network of ground-based gravitational wave detectors promises to improve our capacity to infer the sky-localization of transient sources, enabling more effective multi-messenger follow-ups. At the…