相关论文: PAPR-Limited Precoding in Massive MIMO Systems wit…

Hybrid analog-digital architectures are considered as promising candidates for implementing millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems since they enable a considerable reduction of the required number of…

Hybrid analog/digital precoding in millimeter-wave (mmWave) multi-input multi-ouput (MIMO) systems is capable of achieving the near-optimal full-digital performance at reduced hardware cost and power consumption compared to its full-RF…

In massive MIMO systems, fully digital precoding offers high performance but has significant implementation complexity and energy consumption, particularly at millimeter frequencies and beyond. Hybrid analog-digital architectures provide a…

Millimeter-wave (mmWave) communication operated in frequency bands between 30 and 300 GHz has attracted extensive attention due to the potential ability of offering orders of magnitude greater bandwidths combined with further gains via…

Millimeter wave (mmWave) massive MIMO can achieve orders of magnitude increase in spectral and energy efficiency, and it usually exploits the hybrid analog and digital precoding to overcome the serious signal attenuation induced by mmWave…

A variety of hybrid analog-digital beamforming architectures have recently been proposed for massive multiple-input multiple-output (MIMO) systems to reduce energy consumption and the cost of implementation. In the analog processing network…

Multiple-input multiple-output (MIMO) communication has led to immense enhancements in data rates and efficient spectrum management. The evolution of MIMO, though, has been accompanied by increased hardware complexity and array sizes,…

In massive MIMO systems, hybrid beamforming is an essential technique for exploiting the potential array gain without using a dedicated RF chain for each antenna. In this work, we consider the data phase in a massive MIMO communication…

Antenna arrays will be an important ingredient in millimeter wave (mmWave) cellular systems. A natural application of antenna arrays is simultaneous transmission to multiple users. Unfortunately, the hardware constraints in mmWave systems…

Dealing with nonlinear effects of the radio-frequency(RF) chain is a key issue in the realization of very large-scale multi-antenna (MIMO) systems. Achieving the remarkable gains possible with massive MIMO requires that the signal…

Configuring hybrid precoders and combiners is a major challenge to deploy practical mmWave communication systems. Prior work addresses the problem of designing hybrid precoders and combiner, yet focusing on finding solutions under a total…

Hybrid analog/digital MIMO architectures were recently proposed as an alternative for fully-digitalprecoding in millimeter wave (mmWave) wireless communication systems. This is motivated by the possible reduction in the number of RF chains…

Hybrid analog-digital precoding is a key millimeter wave access technology, where an antenna array with reduced number of radio frequency (RF) chains is used with an RF precoding matrix to increase antenna gain at a reasonable cost.…

Massive MIMO requires a large number of antennas and the same amount of power amplifiers (PAs), one per antenna. As opposed to 4G base stations, which could afford highly linear PAs, next-generation base stations will need to use…

Millimeter wave (mmWave) communications have been considered as a key technology for next generation cellular systems and Wi-Fi networks because of its advances in providing orders-of-magnitude wider bandwidth than current wireless…

Hybrid analog/digital precoding architectures can address the trade-off between achievable spectral efficiency and power consumption in large-scale MIMO systems. This makes it a promising candidate for millimeter wave systems, which require…

Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…

Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…

Millimeter-wave (mmWave) technology is one of the most promising candidates for future wireless communication systems as it can offer large underutilized bandwidths and eases the implementation of large antenna arrays which are required to…

In this paper, we consider a generalized sub-array-connected (GSAC) architecture for arbitrary radio frequency (RF) chain and antenna configurations, where the number of RF chains connected to a sub-array and the number of antennas in each…