相关论文: Bound on Peak-to-Average Power Ratio with Moment a…

High variations in the OFDM signal envelope cause nonlinear distortion in the power amplifier of the transmitter, which is a major drawback. Peak-to-Average Power Ratio (PAPR) and Cubic Metric (CM) are commonly used for quantifying this…

Optimal power allocation (PA) strategies can make a significant rate improvement in secure spatial modulation (SM). Due to the lack of secrecy rate (SR) closed-form expression in secure SM networks, it is hard to optimize the PA factor. In…

Probabilistic shaping for intensity modulation and direct detection (IM/DD) links is discussed and a peak power constraint determined by the limited modulation extinction ratio (ER) of optical modulators is introduced. The input…

Active Constellation Extension (ACE) is one of techniques introduced for Peak to Average Power Ratio (PAPR) reduction for OFDM systems. In this technique, the constellation points are extended such that the PAPR is minimized but the minimum…

Post-selection strategies have been proposed with the aim of amplifying weak signals, which may help to overcome detection thresholds associated with technical noise in high-precision measurements. Here we use an optical setup to…

High peak-to-average power ratio (PAPR) is a critical problem in orthogonal frequency-division multiplexing (OFDM). The fifth-generation New Radio (5G NR) facilitates the utilization of multiple heterogeneous bandwidth parts (BWPs), which…

We consider an opportunistic cognitive radio network, consisting of Nu secondary users (SUs) and an access point (AP), that can access a spectrum band licensed to a primary user. Each SU is capable of harvesting energy, and is equipped with…

Performance of optimization on quadratic problems sensitively depends on the low-lying part of the spectrum. For large (effectively infinite-dimensional) problems, this part of the spectrum can often be naturally represented or approximated…

Nonlinear distortion of an OFDM signal is a serious problem when it comes to energy-efficient Power Amplifier(PA) utilization. Typically, Peak-to-Average Power Ratio(PAPR) reduction algorithms and digital predistortion algorithms are used…

In the theory of wireless communications, average performance measures (APMs) are widely utilized to quantify the performance gains/impairments in various fading environments under various scenarios, and to comprehend how the factors…

Hybrid automatic repeat 1 request (HARQ) is a key enabler for ultrareliable communications. This paper optimizes transmit power for the initial transmission and the subsequent retransmissions of HARQ with either incremental redundancy or…

In this paper, we address a crucial but often overlooked issue in applying reinforcement learning (RL) to radio resource management (RRM) in wireless communications: the mismatch between the discounted reward RL formulation and the…

We consider the problem of modulating the value of a parameter onto a band-limited signal to be transmitted over a continuous-time, additive white Gaussian noise (AWGN) channel, and estimating this parameter at the receiver. The performance…

Significant improvements have been achieved in motion control systems with the availability of high speed power switches and microcomputers on the market. Even though motor drivers are able to provide high torque control bandwidth under…

Wireless communication systems that rely on orthogonal frequency-division multiplexing (OFDM) suffer from a high peak-to-average (power) ratio (PAR), which necessitates power-inefficient radio-frequency (RF) chains to avoid an increase in…

Increasing demands on high data rate mobile communications services will inevitably drive future broadband mobile communication systems toward achieving data transmission rates in excess of 100 Mbps. One of the promising technologies which…

In this letter, we propose a low complex data-null subcarrier switching-based peak-to-average power ratio (PAPR) reduction scheme for the orthogonal frequency division multiplexing (OFDM) systems, which provides improved bit error rate. We…

Orthogonal frequency division multiplexing (OFDM) signals have high peak-to-average power ratio (PAPR), which causes distortion when OFDM signal passes through a nonlinear high power amplifier (HPA). A partial transmit sequence (PTS) scheme…

This paper investigates the average throughput of a wireless powered communications system, where an energy constrained source, powered by a dedicated power beacon (PB), communicates with a destination. It is assumed that the PB is capable…

In this paper, a new peak-to-average power ratio (PAPR) reduction scheme for orthogonal frequency division multiplexing (OFDM) is proposed based on the selected mapping (SLM) scheme. The proposed SLM scheme generates alternative OFDM signal…