相关论文: Ergodic Rate Analysis of Cooperative Ambient Backs…
This letter introduces a novel wireless-powered backscatter communication system which allows sensors to utilize RF signals transmitted from a dedicated RF energy source to transmit data. In the proposed system, when the RF energy source…
Cell-free massive MIMO and symbiotic radio are promising beyond 5G (B5G) networking architecture and transmission technology, respectively. This paper studies cell-free symbiotic radio systems, where a number of distributed access points…
We study RF-enabled wireless energy transfer (WET) via energy beamforming, from a multi-antenna energy transmitter (ET) to multiple energy receivers (ERs) in a backscatter communication system, such as RFID, where each ER (or RFID tag)…
Radio-frequency energy harvesting constitutes an effective way to prolong the lifetime of wireless networks, wean communication devices off the battery and power line, benefit the energy saving and lower the carbon footprint of wireless…
The emerging pinching antenna (PA) technology enables flexible antenna positioning for creating line-of-sight (LoS) links, thus offering substantial potential to facilitate ambient signal-based backscatter communication (BSC). This paper…
The potential of Wi-Fi backscatter communications systems is immense, yet challenges such as signal instability and energy constraints impose performance limits. This paper introduces FlexScatter, a Wi-Fi backscatter system using a designed…
Ambient backscatter communication is a newly emerged paradigm, which utilizes the ambient radio frequency (RF) signal as the carrier to reduce the system battery requirement, and is regarded as a promising solution for enabling large scale…
Cooperative beamforming (CB) has been proposed as a special case of coordinated multi-point techniques in wireless communications. In wireless sensor networks, CB can enable low power communication by allowing a collection of sensor nodes…
Backscatter communication (BSC) technology can enable ubiquitous deployment of low-cost sustainable wireless devices. In this work we investigate the efficacy of a full-duplex multiple-input-multiple-output (MIMO) reader for enhancing the…
The scaling laws of the achievable communication rates and the corresponding upper bounds of distributed reception in the presence of an interfering signal are investigated. The scheme includes one transmitter communicating to a remote…
Ambient Backscatter Communication (AmBC) is an emerging communication technology that can enable green Internet-of-Things deployments. The widespread acceptance of this paradigm is limited by low Signal-to-Interference-Plus-Noise Ratio…
Wirelessly powered backscatter communication (WPBC) has been identified as a promising technology for low-power communication systems, which can reap the benefits of energy beamforming to improve energy transfer efficiency. However,…
In this paper, we consider a novel ambient backscatter multiple-access system, where a receiver (Rx) simultaneously detects the signals transmitted from an active transmitter (Tx) and a backscatter Tag. Specifically, the…
In ambient re-scatter communications, devices convey information by modulating and re-scattering the radio frequency signals impinging on their antennas. In this correspondence, we consider a system consisting of a legacy modulated…
Backscattering assisted wireless-powered communication combines ultralow-power backscatter transmitters with energy harvesting devices. This paper investigates the transmission mode selection problem of a hybrid relay that forwards data by…
Ambient backscatter communication (AmBC) is becoming increasingly popular for enabling green communication amidst the continual development of the Internet-of-things paradigm. Efforts have been put into backscatter signal detection as the…
Wireless sensors in extreme environments such as underground, concrete wall, and the human body, can enable a large number of important applications. However, deploying wireless sensors in such environments on a large scale is a great…
Channel state information (CSI) at the transmitter is of importance to the performance of physical layer security based on multi-antenna networks. Specifically, CSI is not only beneficial to improve the capacity of the legitimate channel,…
This paper considers a system where one transmitter broadcasts a single common message to two receivers linked by a bidirectional cooperation channel, which is assumed to be orthogonal to the downlink channel. Assuming a simplified setup…
Ambient Internet of Things networks use low-cost, low-power backscatter tags in various industry applications. By exploiting those tags, we introduce the integrated sensing and backscatter communication (ISABC) system, featuring multiple…