相关论文: Hop-by-Hop Multipath Routing: Choosing the Right N…

Single path routing that is currently used in the internet routers,is easy to implement as it simplifies the routing tables and packet flow paths. However it is not optimal and has shortcomings in utilizing the network resources optimally,…

State-of-the-art Internet traffic engineering uses source-based explicit routing via MPLS or Segment Routing. Though widely adopted in practice, source routing can face certain inefficiencies and operational issues, caused by its use of…

A weakness of next-hop routing is that following a link or router failure there may be no routes between some source-destination pairs, or packets may get stuck in a routing loop as the protocol operates to establish new routes. In this…

Multi-hop uncrewed aerial vehicle (UAV) networks are promising to extend the terrestrial network coverage. Existing multi-hop UAV networks employ a single routing path by selecting the next-hop forwarding node in a hop-by-hop manner, which…

Internet is composed of numbers of independent autonomous systems. BGP is used to disseminate reachability information and establishing path between autonomous systems. Each autonomous system is allowed to select a single route to a…

Link state routing protocols such as OSPF or IS-IS currently use only best paths to forward IP packets throughout a domain. The optimality of sub-paths ensures consistency of hop by hop forwarding although paths, calculated using Dijkstra…

This paper presents a dual method of closed-form analysis and lightweight simulation that enables an evaluation of the performance of mobile ad hoc networks that is more realistic, efficient, and accurate than those found in existing…

Multipath routing is a trivial way to exploit the path diversity to leverage the network throughput. Technologies such as OSPF ECMP use all the available paths in the network to forward traffic, however, we argue that is not necessary to do…

In this paper, we consider the bandwidth-delay-hop constrained routing problem in large-scaled software defined networks. A number of demands, each of which specifies a source vertex and a sink vertex, are required to route in a given…

We investigate the problem of designing delay-aware joint flow control, routing, and scheduling algorithms in general multi-hop networks for maximizing network utilization. Since the end-to-end delay performance has a complex dependence on…

In this work, multi-step traffic predictions are leveraged to enable multi-period planning in reconfigurable optical networks. The proposed framework aims to achieve spectrum savings by adapting the network to predicted time-varying…

This paper considers networks where user traffic is regulated through deterministic traffic profiles, e.g., token buckets, and requires hard delay bounds. The network's goal is to minimize the resources it needs to meet those bounds. The…

In this paper we present a new routing paradigm that generalizes opportunistic routing for wireless multihop networks. In multirate anypath routing, each node uses both a set of next hops and a selected transmission rate to reach a…

In this paper, we consider the problem of link scheduling in multi-hop wireless networks under general interference constraints. Our goal is to design scheduling schemes that do not use per-flow or per-destination information, maintain a…

This paper considers a multi-UAV network with a ground station (GS) that uses multi-hop relaying structure for data transmission in a power-efficient manner. The objective is to investigate the best possible multi-hop routing structure for…

This paper develops upper bounds on the end-to-end transmission capacity of multi-hop wireless networks. Potential source-destination paths are dynamically selected from a pool of randomly located relays, from which a closed-form lower…

Routing is a widespread approach to transfer information from a source node to a destination node in many deployed wireless ad-hoc networks. Today's implemented routing algorithms seek to efficiently find the path/route with the largest…

Maximum throughput requires path diversity enabled by bifurcating traffic at different network nodes. In this work, we consider a network where traffic bifurcation is allowed only at a subset of nodes called \emph{routers}, while the rest…

A significant challenge for computation offloading in wireless multi-hop networks is the complex interaction among traffic flows in the presence of interference. Existing approaches often ignore these key effects and/or rely on outdated…

The Internet provides physical path diversity between a large number of hosts, making it possible for networks to use alternative paths when one path fails to deliver the required Quality of Service. However, for various reasons, many…