相关论文: An efficient solution for accelerating very high i…
The CSR-LINAC injector has been proposed in Heavy Ion Research Facility in Lanzhou (HIRFL). The linac mainly consists of two parts, the RFQ and the IH-DTL. The KONUS (Kombinierte Null Grad Struktur) concept has been introduced into the DTL…
Room temperature IH-type drift tube structures are used at different places now for the acceleration of ions with mass over charge ratios up to 65 and velocities between 0.016 c and 0.1 c. These structures have a high shunt impedance and…
KONUS beam dynamics design of uranium DTL with LORASR code is presented. The 238U34+ beam, whose current is 5.0emA, is accelerated from injection energy of 0.35MeV/u to output energy of 1.3MeV/u by IH-DTL operated at 81.25MHz in HIAF…
The first phase of the HIE-ISOLDE project at CERN consists of a superconducting (SC) linac upgrade in order to increase the energy of post-accelerated radioactive ion beams from 2.8 MeV/u to over 10 MeV/u (for A/q = 4.5). In preparation for…
We have developed high-efficiency normal-conducting RF accelerating structures by combining H-mode resonator cavities and a transverse beam focusing by permanent-magnet quadrupoles (PMQ), for beam velocities in the range of a few percent of…
A high peak current, flat longitudinal phase space electron beam is desirable for efficient x-ray free electron laser (FEL) radiation in next generation light sources. To attain such a beam requires the extensive design of the linear…
Based on the design requirements proposed by the Beijing On-Line Isotope Separation project (BISOL), four Sn$^{22+}$-based,81.25MHz continuous wave (CW) drift tube linac (DTL) cavities have been designed. These DTLs are capable of…
A dielectric-loaded linac powered by THz-pulses is one of the key parts of the "Attosecond X-ray Science: Imaging and Spectroscopy" (AXSIS) project at DESY, Hamburg. As in conventional accelerators, the AXSIS linac is designed to have phase…
In accelerators, ion beams are often accelerated using electrostatic accelerating tubes. This paper reports on a method to improve the beam transport efficiency without adding new components to the beam transport system. High beam currents…
The superconducting (SC) High Intensity and Energy (HIE) ISOLDE linac will replace most of the existing accelerating infrastructure of the Radioactive ion beam EXperiment (REX) at CERN, however, the 101.28 MHz RFQ and 5 MV IH cavity will…
The upgrade of the normal conducting (NC) Radioactive Ion Beam EXperiment (REX)-ISOLDE heavy ion accelerator at CERN, under the High Intensity and Energy (HIE)-ISOLDE framework, proposes the use of superconducting (SC) quarter-wave…
The conception of High Power Linac developed in Russian accelerator centres is based on the use of independently phased SC resonators with quadrupole lenses between them. The type and parameters of the resonators as well as focusing…
The 750-keV low-energy beam transport of the Los Alamos Neutron Science Center (LANSCE) linac consists of two independent beam lines that facilitate simultaneous injection of H+ and H- beams into the linear accelerator. The efficiency of…
Compact laser-plasma acceleration of fast ions has made great strides since its discovery over two decades ago, resulting in the current generation of high-energy ($\geq 100\,\rm MeV$) ultracold beams over ultrashort ($\leq 1\,\rm ps$)…
The novel combination of a strongly-resonant optical metasurface with the MoS$_2$/WSe$_2$ hetero-bilayer is proposed for efficient free-space lasing enabled by the enhanced coupling between the optical and matter (exciton) states. The…
Efficient transport of high-current negative ion beams is critical for accurate plasma potential diagnostics using heavy-ion beam probe (HIBP) systems in magnetically confined fusion plasmas. However, strong space-charge effects often…
LINAC 4 is a normal conducting H- structure proposed to intensify the proton flux currently available for the CERN accelerator chain. This linac is designed to accelerate a 65 mA beam up to 160 MeV to be injected into the CERN Proton…
Large energy acceptance arcs have been proposed for applications such as cancer therapy, muon accelerators, and recirculating linacs. The efficacy of charged particle therapy can be improved by reducing the energy layer switching time,…
The development of Ultra-High Frequency (UHF) linear accelerators via Metal Additive Manufacturing (MAM) is a strategic research focus of the RACERS team at GSI. The 704.4 MHz Crossbar H-mode (CH) cavity, proposed in 2021 to facilitate…
In the present paper we introduce a new accelerator concept for ions. The accelerator is nano-structured and can consist of a range of materials. It is capable of generating large ionic currents at moderate ion energies. The nano-structures…