相关论文: Shape Memory Polymer Resonators as Highly Sensitiv…
In nanomechanical photothermal absorption spectroscopy and microscopy, the measured substance becomes a part of the detection system itself, inducing a nanomechanical resonance frequency shift upon thermal relaxation. Suspended,…
In the field of radiowave detection, enlarging the receiver aperture to enhance the amount of light detected is essential for greater scientific achievements. One challenge in using radio transmittable apertures is keeping the detectors…
Large dynamic range room temperature photon number resolving (PNR) detectors can be very useful for measuring very low light intensities and for analyzing multiphoton quantum states. In this paper we present a PNR detector based on the…
Silicon's bandgap inherently restricts its photodetection to wavelengths below 1100 nm, necessitating the integration of costly III-V semiconductors for short-wave infrared applications. Hyperdoping silicon beyond the solid solubility limit…
A high-sensitivity thermal sensing is demonstrated by coating a layer of polydimethylsiloxane (PDMS) on the surface of a silica toroidal microresonator on a silicon wafer. Possessing high-Q whispering gallery modes (WGMs), the PDMS-coated…
The infrared (IR) photoresponse of graphene synthesized by an atmospheric chemical vapor deposition (CVD) system using a mixture of hydrogen and methane gases was studied. The IR sensor devices were fabricated using graphene films…
Measuring temperature fields in semi-transparent media requires the knowledge of material thermo-optic properties. While the current techniques are well established for isothermal thin films, they remain unexplored for thick media where…
Spectral imaging and detection of mid-infrared (mid-IR) wavelengths are emerging as an enabling technology of great technical and scientific interest; primarily because important chemical compounds display unique and strong mid-IR spectral…
Bolometers are a powerful and vital means of detecting light in the IR to THz frequencies, and they have been adopted for a range of uses from astronomical observation to thermal imaging. As uses diversify, there is an increasing demand for…
High-sensitivity long-wave infrared (LWIR) detection is crucial for observing weak thermal radiation. Recently, the Poisson bolometer has been proposed as a fundamentally new platform for uncooled infrared detection. In contrast to…
We demonstrate a thermal infrared (IR) detector based on an ultra-high-quality-factor (Q) whispering-gallery-mode (WGM) microtoroidal silica resonator, and investigate its performance to detect IR radiation at 10 micron wavelength. The…
In this work, we investigate dielectric materials for thermoreflectance-based thermal sensing by extracting key optical parameters using temperature-dependent spectroscopic ellipsometry in the mid-infrared regime. Leveraging optical phonon…
On-chip photodetectors are essential components in optical communications as they convert light into an electrical signal. Photobolometers are type of photodetector that functions through a resistance change caused by electronic temperature…
Photodetectors are typically based on photocurrent generation from electron-hole pairs in semiconductor structures and on bolometry for wavelengths that are below bandgap absorption. In both cases, resonant plasmonic and nanophotonic…
We report on a non-interacting technique for thermal characterization of fluids based on surface plasmon resonance interrogation. Using liquid volumes less than 20 micro liters we have determined the materials' thermo-optic coefficients…
A network identification by deconvolution (NID) method is applied to the thermal transient response of packaged and unpackaged microcoolers. A thin film resistor on top of the device is used as the heat source and the temperature sensor.…
Photothermal-Induced Resonance (PTIR) is increasingly used in the measurement of infrared absorption spectra of sub-micrometer objects. The technique measures IR absorption spectra by relying on the photothermal effect induced by a rapid…
We established a production method of a good millimeter-wave absorber by using a 3D-printed mold. The mold has a periodic pyramid shape, and an absorptive material is filled into the mold. This shape reduces the surface reflection. The…
We present an approach to fabrication and packaging of integrated photonic devices that utilizes waveguide and detector layers deposited at near-ambient temperature. All lithography is performed with a 365 nm i-line stepper, facilitating…
Si-based photodetectors satisfy the criteria of low-cost and environmental-friendly, and can enable the development of on-chip complementary metal-oxide-semiconductor (CMOS)-compatible photonic systems. However, extending their…