相关论文: The integrated low-level trigger and readout syste…
A Time to Digital Converter (TDC) based system, to be used for most sub-detectors in the high-flux rare-decay experiment NA62 at CERN SPS, was built as part of the NA62 fully digital Trigger and Data AcQuisition system (TDAQ), in which the…
The WaveDAQ is a newly-designed digitization Trigger and Data AcQuisition system (TDAQ) allowing Multi-gigasample waveform recording on a large amount of channels (up to 16384) by using the DRS4 analog switched capacitor array as…
The XENONnT detector uses the latest and largest liquid xenon-based time projection chamber (TPC) operated by the XENON Collaboration, aimed at detecting Weakly Interacting Massive Particles and conducting other rare event searches. The…
The NA62 experiment is designed to measure the ultra-rare decay $K^+ \rightarrow \pi^+ \nu \bar{\nu}$ branching ratio with a precision of $\sim 10\%$ at the CERN Super Proton Synchrotron (SPS). The trigger system of NA62 consists in three…
The multilevel trigger system of the DIRAC experiment at CERN is presented. It includes a fast first level trigger as well as various trigger processors to select events with a pair of pions having a low relative momentum typical of the…
A new FPGA-based low-level trigger processor has been installed at the NA62 experiment. It is intended to extend the features of its predecessor due to a faster interconnection technology and additional logic resources available on the new…
The NA62 experiment at CERN SPS started physics data taking this year with the aim to measure the ultra-rare decay $K^+\to\pi^+\nu\bar{\nu}$. The experiment consists of a large number of subsystems to reach the goal of 10% accuracy and less…
The FASER experiment is a new small and inexpensive experiment that is placed 480 meters downstream of the ATLAS experiment at the CERN LHC. FASER is designed to capture decays of new long-lived particles, produced outside of the ATLAS…
The NA62 experiment at the CERN SPS aims at measuring the ultra-rare decay $K^+ \to \pi^+ \nu \bar{\nu}$ with 10% accuracy. This can be achieved by detecting about 100 Standard Model events with 10% background in 2-3 years of data taking.…
The XENON1T liquid xenon time projection chamber is the most sensitive detector built to date for the measurement of direct interactions of weakly interacting massive particles with normal matter. The data acquisition system (DAQ) is…
This paper describes the hardware, firmware and software systems used in data acquisition for the NA61/SHINE experiment at the CERN SPS accelerator. Special emphasis is given to the design parameters of the readout electronics for the 40m^3…
XDAQ is a generic data acquisition software environment that emerged from a rich set of of use-cases encountered in the CMS experiment. They cover not the deployment for multiple sub-detectors and the operation of different processing and…
We give an overview of the main features of the CMS trigger and data acquisition (DAQ) system. Then, we illustrate the strategies and trigger configurations (trigger tables) developed for the detector calibration and physics program of the…
The Nab experiment will measure the electron-neutrino correlation and Fierz interference term in free neutron beta decay to test the Standard Model and probe Beyond the Standard Model Physics. Using National Instrument's PXIe-5171…
APEIRON is a framework encompassing the general architecture of a distributed heterogeneous processing platform and the corresponding software stack, from the low level device drivers up to the high level programming model. The framework is…
Large Liquid Argon TPC detectors in the range of multikton mass for neutrino and astroparticle physics require the extraction and treatment of signals from some 105 wires. In order to enlarge the throughtput of the DAQ system an on-line…
The BaBar online data acquisition (DAQ) system includes approximately fifty Unix systems that collectively implement the level-three trigger. These systems all run the same code. Each of these systems has its own state, and this state is…
This paper develops a Nearly Autonomous Management and Control (NAMAC) system for advanced reactors. The development process of NAMAC is characterized by a three layer-layer architecture: knowledge base, the Digital Twin (DT) developmental…
The LHC trigger and data acquisition systems will need significant modifications to operate at the HL-LHC. Due to the increased occupancy of each crossing, Level-1 trigger systems would experience degraded performance of the LHC algorithms…
The NA62 experiment at CERN utilises a differential Cherenkov counter with achromatic ring focus (CEDAR) for tagging kaons within an unseparated monochromatic beam of charged hadrons. The CEDAR-H detector was developed to minimise the…