相关论文: A 15-MW Proton Driver for Neutrino Oscillation Exp…
This conceptual design report provides a detailed account of the European Spallation Source neutrino Super Beam (ESS$\nu$SB) feasibility study. This facility has been proposed after the measurements reported in 2012 of a relatively large…
A single gap, 352 MHz superconducting reentrant cavity for 5-100 MeV beams has been designed and it is presently under construction. This development is being done in the framework of a 30 mA proton linac project for nuclear waste…
A new experimental area designed to develop, test and verify muon ionization cooling apparatus using the 400-MeV Fermilab Linac proton beam has been fully installed and is presently being commissioned. Initially, this area was used for…
The possibility of making a low cost, very intense high energy proton source at the Brookhaven Alternating Gradient Synchrotron (AGS) along with the forthcoming new large underground detectors at either the National Underground Science…
An "ultimate" high intensity proton source for neutrino factories and/or muon colliders was projected to be a ~4 MW multi-GeV proton source providing short, intense proton pulses at ~15 Hz. The JPARC ~1 MW accelerators provide beam at…
In the last ten years the use of proton beams in radiation therapy has become a clinical tool for treatment of deep-seated tumours. LIBO is a RF compact and low cost proton linear accelerator (SCL type) for hadrontherapy. It is conceived by…
After measuring in 2012 a relatively large value of the neutrino mixing angle $\theta_{13}$, the door is now open to observe for the first time a possible CP violation in the leptonic sector. The measured value of $\theta_{13}$ also…
Project-X is a proposed project to be built at Fermi National Accelerator Laboratory with several potential missions. A primary part of the Project-X accelerator chain is a Superconducting linac, and In October 2009 a workshop was held to…
This document describes the concept of a primary electron beam facility at CERN, to be used for dark gauge force and light dark matter searches. The electron beam is produced in three stages: A Linac accelerates electrons from a…
This paper describes the concept of a primary electron beam facility at CERN, to be used for dark gauge force and light dark matter searches. The electron beam is produced in three stages: A Linac accelerates electrons from a photo-cathode…
A muon collider (MC) would require a high-power proton driver to generate intense muon beams at the start of the accelerator chain. Like other high-power facilities, the driver would accumulate intense proton bunches via charge-exchange…
The 1.7-GeV 100-mA CW proton linac is now under design for the Accelerator Production of Tritium (APT) Project. The APT linac comprises both the normal conducting (below 211 MeV) and superconducting (SC) sections. The high current leads to…
Simulations have shown that a high energy, short and intense proton beam can drive a large amplitude plasma wave and accelerate an electron beam to the energy frontier in a single plasma channel. To verify this novel idea, a…
A 5-MeV RFQ designed for a proton current up to 100-mA CW is now under construction as part of the High Intensity Proton Injector project (IPHI). Its computed transmission is greater than 99 %. The main goals of the project are to verify…
We are developing a high-current cyclotron as a driver for the IsoDAR neutrino experiment. It accelerates 5 mA H2+ to 60 MeV/amu, after which the electron is removed to produce a 10 mA, 60 MeV proton beam. The enabling innovations that…
Experimental and theoretical activities are underway at CERN with the aim of examining the feasibility of a very-high-flux neutrino source. In the present scheme, a high-power proton beam (some 4 MW) bombards a target where pions are…
Performances of a neutrino beam generated by the CERN SPL proton driver are computed considering a 440 kton water Cerenkov detector at 130 km from the target. $\theta_{13}$ sensitivity down to $1.2^\circ$ and a $\delta$ sensitivity…
PIP-II is an essential upgrade of the Fermilab complex that will enable the worlds most intense high-energy beam of neutrinos for the international Deep Underground Neutrino Experiment at LBNF and support a broad physics program at…
A new compact linear proton accelerator project (named LINAC 7) for multiple low-current applications, designed and built in-house at the Beam Laboratory of the University of the Basque Country (UPV/EHU) is described. The project combines…
The continue wave (CW) high current proton linac has wide applications as the front end of the high power proton machines. The low energy part is the most difficult one and there is no widely accepted solution yet. Based on the analysis of…