相关论文: A Case for Digital Beamforming at mmWave
Beamforming has significance for enhancing spectral efficiency and mitigating interference in multi-antenna wireless systems, facilitating spatial multiplexing and diversity in dense and high mobility scenarios. Traditional beamforming…
Low-resolution digital-to-analog converters (DACs) and analog-to-digital converters (ADCs) are considered to reduce cost and power consumption in multiuser massive multiple-input multiple-output (MIMO). Using the Bussgang theorem, we derive…
In this letter, the maximization of resistible jamming power is studied for multi-user downlink millimeter-wave cell-free multiple-input-multiple-output (CF-MIMO) systems. We propose an alternate optimization-based anti-jamming hybrid…
There is considerable interest in the combined use of millimeter-wave (mmwave) frequencies and arrays of massive numbers of antennas (massive MIMO) for next-generation wireless communications systems. A symbiotic relationship exists between…
This paper proposes a novel broadband transmission technology, termed delay alignment modulation (DAM), which enables the low-complexity equalization-free single-carrier communication, yet without suffering from inter-symbol interference…
Microwave linear analog computing (MiLAC) has recently emerged as a promising architecture for analog-domain beamforming. In particular, a hybrid digital-MiLAC architecture was proposed and was shown to achieve fully-digital beamforming…
In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…
Millimeter-wave (mmWave) using conventional phased array (CPA) enables highly directional and fixed angular beamforming (FAB), therefore enhancing physical layer security (PLS) in the angular domain. However, as the eavesdropper is located…
Millimeter-wave (mmWave) communications rely on directional transmissions to overcome severe path loss. Nevertheless, the use of narrow beams complicates the initial access procedure and increase the latency as the transmitter and receiver…
In millimeter wave (mmWave) systems, we investigate uplink user scheduling when a basestation employs low-resolution analog-to-digital converters (ADCs) with a large number of antennas. To reduce power consumption in the receiver,…
Cell-Free Massive Multiple-input Multiple-output (mMIMO) consists of many access points (APs) in a coverage area that jointly serve the users. These systems can significantly reduce the interference among the users compared to conventional…
Terahertz (THz) communications are regarded as a pillar technology for the sixth generation (6G) wireless systems, by offering multi-ten-GHz bandwidth. To overcome the short transmission distance and huge propagation loss, ultra-massive…
Millimeter-wave (mmWave) hybrid analog-digital beamforming is a promising approach to satisfy the low-latency constraint in multiple unmanned aerial vehicles (UAVs) systems, which serve as network infrastructure for flexible deployment.…
Beamforming (BF) design for large-scale antenna arrays with limited radio frequency chains and the phase-shifter-based analog BF architecture, has been recognized as a key issue in millimeter wave communication systems. It becomes more…
Hybrid precoders and combiners are designed for cooperative cell-free multi-user millimeter wave (mmWave) multiple-input multiple-output (MIMO) cellular networks for low complexity interference mitigation. Initially, we derive an optimal…
Analog-to-digital conversion (ADC) is a key bottleneck in scaling DSP-centric receiver architectures to multiGigabit/s speeds. Recent information-theoretic results, obtained under ideal channel conditions (perfect synchronization, no…
It is known that the estimated energy consumption of digital-to analog converters (DACs) is around 30\% of the energy consumed by analog-to-digital converters (ADCs) keeping fixed the sampling rate and bit resolution. Assuming that…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…
This study considers a novel full-duplex (FD) massive multiple-input multiple-output (mMIMO) system using hybrid beamforming (HBF) architecture, which allows for simultaneous uplink (UL) and downlink (DL) transmission over the same…
We consider general multi-antenna fading channels with coarsely quantized outputs, where the channel is unknown to the transmitter and receiver. This analysis is of interest in the context of sensor network communication where low power and…