相关论文: Sub-6 GHz Microstrip Antenna: Design and Radiation…

This manuscript presents an ultra-wideband Microstrip multiple-input-multiple-output (MIMO) antenna covering the 2.4GHz to 6.5 GHz wireless local networks (WLAN) and Sub-6G bands. The applied MIMO antenna is composed of two symmetrical…

In this paper, a new design for U-shaped microstrip patch antenna is proposed, which can be used in WiMAX communication systems. The aim of this paper is to optimize the performance of microstrip patch antenna. Nowadays, WiMAX communication…

Ultra-wideband is increasingly advancing as a high data rate wireless technology after the Federal Communication Commission announced the bandwidth of 7.5 GHz (from 3.1 GHz to 10.6 GHz) for ultra-wideband applications. Furthermore,…

A parallel dispersive finite-difference time-domain (FDTD) method for the modeling of three-dimensional (3-D) electromagnetic cloaking structures is presented in this paper. The permittivity and permeability of the cloak are mapped to the…

At millimeter-wave frequencies, diffuse scattering from rough surfaces is an important propagation mechanism. Including this mechanism in radio propagation modeling tools,such as ray-tracing, is a key step towards realizing accurate…

A novel and compact dual band planar antenna for 2.4/5.2/5.8-GHz wireless local area network(WLAN) applications is proposed and studied in this paper. The antenna comprises of a T-shaped and a F-shaped element to generate two resonant modes…

This paper presents the design and performance analysis of a 1x6 linear microstrip patch antenna array tailored for automotive radar and 5G millimetre-wave (mm-wave) applications. The proposed antenna array comprises six rectangular…

This paper covers wideband planar antenna design approaches. Modeling and simulation results were obtained using ADS simulation software and have demonstrated feasibility for fabrication of a wideband patch antenna configuration for…

The spatial sensor characteristics of a 6cm TDR flat band cable sensor section was simulated with finite element modelling (High Frequency Structure Simulator-HFSS) under certain conditions: (i) in direct contact to the surrounding material…

This paper presents the ultra-wideband (UWB) on-body radio channel modelling using a sub-band Finite-Difference Time-Domain (FDTD) method and a model combining the uniform geometrical theory of diffraction (UTD) and ray tracing (RT). In the…

Sub-Terahertz (THz) frequencies between 100 GHz and 300 GHz are being considered as a key enabler for the sixth-generation (6G) wireless communications due to the vast amounts of unused spectrum. The 3rd Generation Partnership Project…

For the development of new 5G systems to operate in bands up to 100 GHz, there is a need for accurate radio propagation models at these bands that currently are not addressed by existing channel models developed for bands below 6 GHz. This…

A full three-dimensional Finite-Difference Time-Domain (FDTD)-based toolkit is developed to simulate the whispering gallery modes of a microsphere in the vicinity of a dipole source. This provides a guide for experiments that rely on…

A Microstrip patch array antenna has been designed for 5.62 GHz on FR4 substrate having a dielectric constant of 4.4 and thickness is 1.6 mm.The antenna is used to design for use with a low cost imaging radar MicroSAR. The antenna composed…

This paper proposes a dual-band frequency scanning meandering microstrip leaky-wave antenna with linear polarization in the Ku-band and circular polarization in the K-band. This is achieved by making use of two spatial harmonics for…

Massive multiple-input-multiple-output (MIMO) transmission is a promising technology to improve the capacity and reliability of wireless systems. However, the number of antennas that can be equipped at a base station (BS) is limited by the…

Six-dimensional movable antenna (6DMA) has been identified as a new disruptive technology for future wireless systems to support a large number of users with only a few antennas. However, the intricate relationships between the signal…

In this work, a complementary resonant structure etched on the ground plane of a microstrip line is proposed for characterizing dielectric materials. The resonant sensor is designed to operate in S-band (2 to 4 GHz). The sensor is designed…

In many laboratories, conventional bright-field transmission microscopes are available to study the structure and organization principles of fibrous tissue samples, but they usually provide only 2D information. To access the third…

This research work focuses on the design and simulation of a planar dipole antenna for 1800MHZ Band for Global System Mobile GSM application using Computer Software Technology CST studio software. The antenna is structured on a fire…