相关论文: Active Fault Tolerant Control of Grid-Connected DE…

This paper employs a supervised machine learning (ML) algorithm to propose an integrated fault detection and diagnosis (FDD) and fault-tolerant control (FTC) strategy to detect, diagnose, and classify the grid faults and correct the input…

This paper presents an adaptive fault-tolerant control (FTC) scheme for a class of nonlinear uncertain multi-agent systems. A local FTC scheme is designed for each agent using local measurements and suitable information exchanged between…

PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor…

Recent research has shown that operating grid-connected converters using the grid-forming vector current control (GFVCC) scheme offers significant benefits, including the simplicity and modularity of the control architecture, as well as…

A novel active fault-tolerant control (AFTC) scheme for a dual-system vertical takeoff and landing (VTOL) unmanned aerial vehicle (UAV) during transition flight is proposed in this paper. The AFTC scheme is composed of a baseline control…

An Adaptive Fault-tolerant Controller procedure for a class of the affine nonlinear system is developed in this paper. This methodology hides both the faults and external disturbances. Compare to the procedure that require separate fault…

We present a new output feedback fault tolerant control strategy for continuous-time linear systems. The strategy combines a digital nominal controller under controller-driven (varying) sampling with virtual-actuator (VA)-based controller…

In this paper, a new fault tolerant dc-ac converter-fed induction motor drive is proposed to maintain motor as close as possible to its desired normal operation under open- and short-circuit switch failures. The operational principles for…

An MPC controller uses a model of the dynamical system to plan an optimal control strategy for a finite horizon, which makes its performance intrinsically tied to the quality of the model. When faults occur, the compromised model will…

This paper addresses Fault Tolerant Control (FTC) of Large Power Systems (LPS) subject to sensor failure. Hiding the fault from the controller allows the nominal controller to remain in the loop. We assume specific faults that violate…

This paper proposes a decentralized and coordinated voltage and frequency (Vf) control framework for islanded microgrids, with full consideration of the limited capacity of distributed energy resources (DERs) and Vf dependent load. First,…

Fault detection and reconfiguration in fault-tolerant converters may complicated and necessitate using all-purpose microprocessors and high-speed sensors to guarantee the satisfactory performance of power converters. Therefore, providing…

Voltage support capability is critical for grid-forming (GFM) inverters with current-limiting control (CLC) during grid faults. Despite the findings on the voltage support for symmetrical grid faults, its applicability to more common but…

In this paper we propose a distributed dynamic controller for sharing frequency control reserves of asynchronous AC systems connected through a multi-terminal HVDC (MTDC) grid. We derive sufficient stability conditions, which guarantee that…

In this paper, a new Volt/Var Control (VVC) scheme is proposed to facilitate the coordination between the conventional VVC devices and the new smart PV inverters to provide an effective voltage control on a system with high PV penetration.…

Integration of Inverter Based Resources (IBRs) which lack the intrinsic characteristics such as the inertial response of the traditional synchronous-generator (SG) based sources presents a new challenge in the form of analyzing the grid…

Grid-forming voltage source converter (GF-VSC) has been identified as the key technology for the operation of future converter-dominated power systems. Among many other issues, transient stability of this type of power systems remains an…

This paper aims to develop a Fault Tolerant Control (FTC) architecture, for the case of a damaged actuator for a multirotor UAV that can be applied across multirotor platforms based on their Attainable Virtual Control Set (AVCS). The…

Grid-forming technology has a crucial role in achieving the future all renewable power grid. Among different types of grid-forming controllers, Virtual Oscillator (VO) based Controllers (VOCs) are the most advanced. VOCs outperform the…

This paper shows that a relation can be found between the voltage at the terminals of an inverter-interfaced Renewable Energy Source RES and its optimal reactive power support. This relationship, known as Volt-Var Curve VVC, enables the…