相关论文: Hybrid precoding and combining for frequency-selec…

Although the benefits of precoding and combining of data signals are widely recognized, the potential of these techniques for pilot transmission is not fully understood. This is particularly relevant for multiuser multiple-input…

Modern 5G wireless cellular networks use massive multiple-input multiple-output (MIMO) technology. This concept entails using an antenna array at a base station to concurrently service many mobile devices that have several antennas on their…

Millimeter wave (mmWave) communication is a promising solution for coping with the ever-increasing mobile data traffic because of its large bandwidth. To enable a sufficient link margin, a large antenna array employing directional…

To enable user diversity and multiplexing gains, a fully digital precoding multiple input multiple output (MIMO) architecture is typically applied. However, a large number of radio frequency (RF) chains make the system unrealistic to…

The high energy consumption of massive multi-input multi-out (MIMO) system has become a prominent problem in the millimeter wave(mm-Wave) communication scenario. The hybrid precoding technology greatly reduces the number of radio…

This paper presents an energy-efficient downlink precoding scheme with the objective of maximizing system energy efficiency in a multi-cell massive MIMO system. The proposed precoding design jointly considers the issues of power control,…

Next generation of wireless networks will likely rely on large-scale antenna systems, either in the form of massive multi-input-multi-output (MIMO) or millimeter wave (mmWave) systems. Therefore, the conventional fully-digital precoders are…

Hybrid precoding can significantly reduce the number of required radio frequency (RF) chains and relieve the huge energy consumption in mmWave massive MIMO systems, thus attracting much interests from academic and industry. However, most…

In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…

Millimeter wave (mmWave) is a practical solution to provide high data rate for the vehicle-to-everything (V2X) communications. This enables the future autonomous vehicles to exchange big data with the base stations (BSs) such as the…

Precoding design for the downlink of multiuser multiple-input multiple-output (MU-MIMO) systems is a fundamental problem. In this paper, we aim to maximize the weighted sum rate (WSR) while considering both quality-of-service (QoS)…

This paper investigates the joint design of hybrid transmit precoder and analog receive combiners for single-group multicasting in millimeter-wave systems. We propose LB-GDM, a low-complexity learning-based approach that leverages gradient…

Large-scale MIMO systems have been considered as one of the possible candidates for the next-generation wireless communication technique, due to their potential to provide significant higher throughput than conventional wireless systems.…

Hybrid precoding has been recently proposed as a cost-effective transceiver solution for millimeter wave (mm-wave) systems. While the number of radio frequency (RF) chains has been effectively reduced in existing works, a large number of…

In this paper, we propose a new hybrid analog and digital combining architecture for millimeter wave (mmWave) multi-user multiple-input multiple-output (MU-MIMO) systems. The proposed structure employs antenna subset selection per radio…

To utilize the full potential of the available power at a base station (BS), we propose a joint precoding, antenna selection, and transmit power control algorithm for a total power budget at the BS. We formulate a sum spectral efficiency…

In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…

Hybrid transceiver can strike a balance between complexity and performance of multiple-input multiple-output (MIMO) systems. In this paper, we develop a unified framework on hybrid MIMO transceiver design using matrix-monotonic…

A network relying on a large antenna-array-aided base station is designed for delivering multiple information streams to multi-antenna users over high-frequency bands such as the millimeter-wave and sub-Terahertz bands. The state-of-the-art…

For the practical implementation of massive multiple-input multiple-output (MIMO) systems, the hybrid processing (precoding/combining) structure is promising to reduce the high cost rendered by large number of RF chains of the traditional…