相关论文: Microstructure and formation mechanisms of {\delta…
Zircaloy-4 is used as a fuel cladding material for water reactors, as it has good mechanical properties, corrosion resistance, and a low thermal neutron absorption cross section. However, the mechanical performance of Zircaloy-4 can be…
We explore the distribution, morphology and structure of zirconium hydrides formed using different cooling rates through the solid state Zr+[H] --> Zr + hydride transus, in fine and blocky alpha Zircaloy-4. We observe that cooling rate and…
The long-term safety of water-based nuclear reactors relies in part on the reliability of zirconium-based nuclear fuel. Yet the progressive ingress of hydrogen during service makes zirconium alloys subject to delayed hydride cracking. Here,…
Zircaloy-4 is used extensively as nuclear fuel cladding materials and hydride embrittlement is a major failure mechanism. To explore the effect of {\delta}-hydride on plastic deformation and performance of Zircaloy-4, in situ high angular…
The interaction of hydrogen and metals continues to be industrially relevant and is a critical part of creating and supporting a safety case for nuclear reactor operation. In the present work, we explore hydrogen storage and hydride…
Zirconium alloys are widely used in nuclear reactors as fuel cladding materials. Fuel cladding is used to contain the nuclear fuel and cladding tubes are typically sealed using welds. Welding of zirconium alloys can result in changes in the…
A recently developed full field level-set model of continuous dynamic recrystallization is applied to simulate zircaloy-4 recrystallization during hot compression and subsequent heat treatment. The influence of strain rate, final strain and…
The present article proposes a detailed study of recrystallization of zircaloy-4 under hot forming conditions by means of experimental and numerical tools. Thermomechanical tests and characterization campaigns that have been necessary for…
High-energy synchrotron X-ray diffraction was utilized to study the mechanical response of the f.c.c $\delta$-hydride phase, the intermetallic precipitation with hexagonal C14 lave phase and the $\alpha$-Zr phase in the Zircaloy-4 materials…
One of the main degradation mechanisms of the zirconium alloys used in nuclear reactors is hydrogen embrittlement and hydride formation. The formation of zirconium hydrides is accompanied by a transformation strain, the effects of which on…
We used by in-situ high energy X-ray diffraction to inestigate the deformation behavior of Grade 2 commercially pure titanium that was hydrogen charged to form hydrides. The results showed that the peak broadening in the diffraction…
The effects of applied load on the formation and reorientation of delta hydrides in alpha-zirconium matrix are studied by a multiphase field model. Simulations with only one hydride seed indicate that the hydride reorientation occurs only…
The interactions between {\delta}-hydrides and plastic slip in a commercial zirconium alloy, Zircaloy-4, under stress were studied using in situ secondary electron microscope (SEM) micropillar compression tests of single crystal samples and…
The internal energy associated with the defect microstructure of strongly deformed crystals provides an important driving force for grain boundary motion during recrystallization. Typical dislocation microstructures are strongly…
Revealing statistics of H-defect interactions provides insights into significant ductility loss due to the particular strain partitioning in H-charged structural alloys. Experimental investigation of these interactions is extremely…
Hydride precipitation in zirconium cladding materials can damage their integrity and durability.Service temperature and material defects have a significant effect on the dynamic growth of hydrides. In this study, we have developed a phase…
Zircaloy-4 (Zr-1.5%Sn-0.2%Fe-0.1%Cr wt. %) was electrochemically charged with deuterium to create deuterides and subsequently analysed with atom probe tomography and scanning transmission electron microscopy to understand zirconium hydride…
We present an original approach for predicting the static recrystallization texture development during annealing of deformed crystalline materials. The microstructure is considered as a population of subgrains and grains whose sizes and…
The fabrication of bulk delta-phase Zirconium Hydride ($\delta$-ZrH) using Zircaloy-4 as a precursor is herein reported. Characterization using electron-microscopy methods indicate that the fabricated material is of a single-phase. Sn-rich…
A continuum dislocation model of formation of grains whose boundaries have a non-vanishing thickness is proposed. For a single crystal deforming in simple shear the lamellar structure of grains with thin layers containing dislocations as…