相关论文: A Convex Hull Based Approach for MIMO Radar Wavefo…

In this paper, we consider a fundamental problem in modern digital communications known as multi-input multi-output (MIMO) detection, which can be formulated as a complex quadratic programming problem subject to unit-modulus and discrete…

A reconfigurable intelligent surface (RIS) is a nearly-passive flat layer made of inexpensive elements that can add a tunable phase shift to the impinging electromagnetic wave and are controlled by a low-power electronic circuit. This paper…

This paper conceives a hybrid beamforming design (HBF) that maximizes the energy efficiency (EE) of an integrated sensing and communication (ISAC)-enabled millimeter wave (mmWave) multiple-input multiple-output (MIMO) system. In the system…

This paper studies the Two-Person Zero Sum(TPZS) game between a Multiple-Input Multiple-Output(MIMO) radar and an extended target with payoff function being the output Signal-to-Interference-pulse-Noise Ratio(SINR) at the radar receiver.…

The future wireless communications are expected to provide new use scenarios with emerging techniques. This paper focuses on vehicle to everything (V2X) network, where vehicles should cooperatively implement information obtaining, data…

Recently, intelligent reflecting surface (IRS) and unmanned aerial vehicle (UAV) have been introduced into wireless communication systems to enhance the performance of air-ground transmission. To make a good balance between performance,…

We present a tiled architecture for computationally efficient digital beamforming for wideband massive MIMO radar, using beamspace dimension reduction for each tile, and coordinated training of reduced-dimension MVDR beamformers across…

This paper studies a downlink multiuser transmit beamforming design under spherical channel uncertainties, using a worst-case robust formulation. This robust design problem is nonconvex. Recently, a convex approximation formulation based on…

In Part I of this paper, we proposed and analyzed a novel algorithmic framework for the minimization of a nonconvex (smooth) objective function, subject to nonconvex constraints, based on inner convex approximations. This Part II is devoted…

This paper studies the problem of robust downlink beamforming design in a multiuser Multi-Input Single-Output (MISO) Cognitive Radio Network (CR-Net) in which multiple Primary Users (PUs) coexist with multiple Secondary Users (SUs). Unlike…

In this study, we consider a spectrum sharing architecture, wherein a multiple-input multiple-output communication system cooperatively coexists with a surveillance radar. The degrees of freedom for system design are the transmit powers of…

This work presents a cognitive radar (CR) framework to enhance remote sensing performance, specifically focusing on tracking multiple targets under unknown disturbances using massive multiple-input multiple-output (MMIMO) systems. Since…

Training beam design for channel estimation with infinite-resolution and low-resolution phase shifters (PSs) in hybrid analog-digital milimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems is considered in this paper.…

The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…

Extensive research on Reconfigurable Intelligent Surfaces (RIS) has primarily focused on optimizing reflective coefficients for passive beamforming in specific target directions. This optimization typically assumes prior knowledge of the…

Integrated sensing and communication (ISAC) has been widely recognized as one of the key technologies for 6G wireless networks. In this paper, we focus on the waveform design of ISAC system, which can realize radar sensing while also…

Dual-function radar-communication (DFRC) technology is emerging in next-generation wireless systems. Reconfigurable intelligent surface (RIS) arrays have been suggested as a crucial sensor component of the DFRC. In this paper, we propose a…

The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…

This paper considers the problem of designing a multilevel pulse width modulated waveform (PWM) with a prescribed harmonic content. Multilevel PWM design plays a major role in many diverse engineering disciplines. In power electronics,…

In colocated multiple-input multiple-output (MIMO) radar using compressive sensing (CS), a receive node compresses its received signal via a linear transformation, referred to as measurement matrix. The samples are subsequently forwarded to…