相关论文: Asymmetrical precipitation on {10-12} twin boundar…
We consider the stability of precipitates formed at grain boundaries (GBs) by radiation-induced segregation in dilute alloys subjected to irradiation. The effects of grain size and misorientation of symmetric-tilt GBs are quantified using…
Aiming at increasing the yield strength of transformation and twinning induced plasticity (TRIP and TWIP) titanium alloys, a dual-phase $\alpha$/$\beta$ alloy is designed and studied. The composition Ti 7Cr 1.5Sn (wt.%) is proposed, based…
Intermetallic precipitates formed in heat-treated and aged Mg-Zn and Mg-Zn-Y alloys have been investigated via electron microscopy. Coarse spheroidal precipitates formed on deformation twin boundaries contained domains belonging to either…
The mechanical properties of Mg-4wt.% Zn alloy single crystals along the [0001] orientation were measured through micropillar compression at 23C and 100C. Basal slip was dominant in the solution treated alloy, while pyramidal slip occurred…
Microstructural analysis of a Mg-Zn alloy deformed at room temperature by high-pressure torsion (HPT) indicates that fine-scale precipitation occurs even without post-deformation heat treatment. Small-angle X-ray scattering detects…
Increasing attention is being paid to $\alpha$$_2$ Ti$_3$(Al,Sn) precipitation from the $\alpha$ phase of titanium alloys owing to its effect on slip band formation, localisation and the implications for fatigue performance in jet engine…
We apply a combinatorial approach to study the influence of Mg concentration on the precipitation kinetics in an Al-Cu-Li alloy using a diffusion couple made by linear friction welding. The precipitation kinetics is monitored in the…
The precipitation microstructure of the \gamma' (AlAg2) intermetallic phase has been examined in aluminium-silver-copper alloys. The microstructure developed in an Al-0.90at.%Ag-0.90at.%Cu alloy was significantly different from that…
Plastic work partitioning was investigated in extruded AZ31B magnesium alloy under loading orientations promoting slip- or twinning-dominated deformation. Slip-dominated deformation exhibits stable plastic flow with approximately 50$\%$ of…
We use first principles calculations to study the influence of thermomechanical loads on the energetics of precipitation in magnesium-aluminum alloys. Using Density Functional Theory simulations, we present expressions of the energy of…
The bonding and stability of MgSi and AlMgSi compounds relevant to AlMgSi alloys is investigated with the use of (L)APW+(lo) DFT calculations. We show that the $\beta$ and $\beta''$ phases found in the precipitation sequence are…
A detailed study of the precipitation of the \gamma' (AlAg2) phase in undeformed aluminium-silver alloys has been conducted. Several previously unreported features were observed, including the formation of discrete three-dimensional…
A polycrystalline plasticity model, which incorporates the contribution of deformation twinning, is proposed. For this purpose, each material point is treated as a composite material consisting of a parent constituent and multiple twin…
One usual way to strengthen a metal is to add alloying elements and to control the size and the density of the precipitates obtained. However, precipitation in multicomponent alloys can take complex pathways depending on the relative…
Twinning is a primary deformation mechanism in Mg alloys. This study focuses on tension twins during uniaxial compression of Mg-Y alloys, with three key aspects: the orientation specificity of twin grains, the relative evolution of CRSS…
Deformation twinning is a form of permanent deformation that is commonly observed in low symmetry crystals such as hexagonal close-packed (hcp) metals. With recent increased interest in using hcp metals, such as magnesium, in structural,…
A high-throughput methodology is proposed, based on the combination of diffusion couples and advanced nanomechanical testing methods, to directly measure alloying effects on the critical resolved shear stress (CRSS) of individual…
A crystallographic displacive model is proposed for the extension twins in magnesium. It is based on a hard-sphere assumption previously used for martensitic transformations. The atomic displacements are established, and the homogeneous…
The interaction between Mg edge basal dislocations and rod-shaped $\beta_1'$-MgZn$_2$ precipitates was studied by atomistic simulations using a new interatomic potential. The atomistic model was carefully built taking into account the…
Twinning is an important deformation mode in plastically deformed hexagonal close-packed materials. The extremely high twin growth rates at the nanoscale make atomistic simulations an attractive method for investigating the role of…