相关论文: Mixed-timescale Per-group Hybrid Precoding for Mul…
Downlink massive multiple-input multiple-output (MIMO) precoding algorithms in frequency division duplexing (FDD) systems rely on accurate channel state information (CSI) feedback from users. In this paper, we analyze the tradeoff between…
The cost of radio frequency (RF) chains is the biggest drawback of massive MIMO millimeter wave networks. By employing spatial modulation (SM), it is possible to implement lower number of RF chains than transmit antennas but still achieve…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…
In massive MIMO systems, hybrid beamforming is an essential technique for exploiting the potential array gain without using a dedicated RF chain for each antenna. In this work, we consider the data phase in a massive MIMO communication…
Rate-splitting multiple access (RSMA) has been studied for multiuser multiple-input multiple-output (MUMIMO) systems especially in the presence of imperfect channel state information (CSI) at the transmitter. However, its precoding designs…
Hybrid analog-digital signal processing (HSP) is an enabling technology to harvest the potential of millimeter-wave (mmWave) massive-MIMO communications. In this paper, we present a general deep learning (DL) framework for efficient design…
Multi-frequency massive multi-input multi-output (MIMO) communication is a promising strategy for both 5G and future 6G systems, ensuring reliable transmission while enhancing frequency resource utilization. Statistical channel state…
Hybrid precoding, which consists of an RF precoder and a baseband precoder, is a popular precoding architecture for massive MIMO due to its low hardware cost and power consumption. In conventional hybrid precoding, both RF and baseband…
In this work, we consider a wireless network with K cooperating transmitters (TXs) serving jointly K receivers (RXs). Due to the practical limitations of the backhaul network, it is relevant to consider a setting where each TX receives its…
Non-orthogonal multiple access (NOMA) has been recently considered in millimeter-wave (mmWave) massive MIMO systems to further enhance the spectrum efficiency. In addition, simultaneous wireless information and power transfer (SWIPT) is a…
Spatial modulation (SM) is a particularly important form of multiple-input-multiple-output (MIMO). Unlike traditional MIMO, it uses both modulation symbols and antenna indices to carry information. In this paper, to avoid the high cost and…
This article is on the energy efficient precoder design in multi-user multiple-input-multiple-output (MU-MIMO) systems which is also robust with respect to the imperfect channel state information (CSI) at the transmitters. In other words,…
Next generation of wireless networks will likely rely on large-scale antenna systems, either in the form of massive multi-input-multi-output (MIMO) or millimeter wave (mmWave) systems. Therefore, the conventional fully-digital precoders are…
Configuring hybrid precoders and combiners is a major challenge to deploy practical mmWave communication systems. Prior work addresses the problem of designing hybrid precoders and combiner, yet focusing on finding solutions under a total…
In this paper, we aim to achieve energy efficient design with minimum hardware requirement for hybrid precoding, which enables a large number of antennas with minimal number of RF chains, and sub-arrayed multiple-input multiple-output…
Hybrid analog-digital precoding significantly reduces the hardware costs in massive MIMO transceivers when compared to fully-digital precoding at the expense of increased transmit power. In order to mitigate the above shortfall, we use the…
This paper develops energy-efficient hybrid beamforming designs for mmWave multi-user systems where analog precoding is realized by switches and phase shifters such that radio frequency (RF) chain to transmit antenna connections can be…
The space limitation and the channel acquisition prevent Massive MIMO from being easily deployed in a practical setup. Motivated by current deployments of LTE-Advanced, the use of multi-polarized antennas can be an efficient solution to…
Reconfigurable intelligent surface (RIS) is regarded as an important enabling technology for the sixth-generation (6G) network. Recently, modulating information in reflection patterns of RIS, referred to as reflection modulation (RM), has…
We consider multi-group multicast precoding designs for cell-free massive multiple-input multiple-output (MIMO) systems. To optimize the transmit and receive beamforming strategies, we focus on minimizing the sum of the maximum mean squared…