相关论文: Genetic Algorithm Assisted Hybrid Beamforming for …

Reconfigurable intelligent surfaces (RIS) can improve signal propagation environments by adjusting the phase of the incident signal. However, optimizing the phase shifts jointly with the beamforming vector at the access point is challenging…

This paper presents an approximate wireless communication scheme for federated learning (FL) model aggregation in the uplink transmission. We consider a realistic channel that reveals bit errors during FL model exchange in wireless…

The beamforming technology with large holographic antenna arrays is one of the key enablers for the next generation of wireless systems, which can significantly improve the spectral efficiency. However, the deployment of large antenna…

This paper proposes a hardware-software co-design approach to efficiently optimize beamforming and port selection in fluid antenna systems (FASs). To begin with, a fluid-antenna (FA)-enabled downlink multi-cell multiple-input…

In this paper, we consider a reconfigurable intelligent surface (RIS)-assisted two-way relay network, in which two users exchange information through the base station (BS) with the help of an RIS. By jointly designing the phase shifts at…

Thanks to the low cost and power consumption, hybrid analog-digital architectures are considered as a promising energy-efficient solution for massive multiple-input multiple-output (MIMO) systems. The key idea is to connect one RF chain to…

Hybrid beamforming (HB) has emerged as a promising technology to support ultra high transmission capacity and with low complexity for Millimeter Wave (mmWave) multiple-input and multiple-output (MIMO) system. However, the design of digital…

Spatial modulation (SM) is a particularly important form of multiple-input-multiple-output (MIMO). Unlike traditional MIMO, it uses both modulation symbols and antenna indices to carry information. In this paper, to avoid the high cost and…

In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…

This paper considers a multicell downlink channel in which multiple base stations (BSs) cooperatively serve users by jointly precoding shared data transported from a central processor over limited-capacity backhaul links. We jointly design…

In this letter, we consider optimal hybrid beamforming design to minimize the transmission power under individual signal-to-interference-plus-noise ratio (SINR) constraints in a multiuser massive multiple-input-multiple-output (MIMO)…

This paper investigates the fronthaul compression problem in a user-centric cloud radio access network, in which single-antenna users are served by a central processor (CP) cooperatively via a cluster of remote radio heads (RRHs). To…

A two-phase beamforming solution for secure communication using untrusted relay nodes is presented. To thwart eavesdropping attempts of relay nodes, we deliberately introduce artificial noise in the source message. After pointing out the…

Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…

In millimeter-wave (mmWave) MIMO systems, while a hybrid digital/analog precoding structure offers the potential to increase the achievable rate, it also faces the challenge of the need of a low-complexity design. In specific, the hybrid…

Modern fronthaul links in wireless systems must transport high-dimensional signals under stringent bandwidth and latency constraints, which makes compression indispensable. Traditional strategies such as compressed sensing, scalar…

This paper proposed new hybrid, analog-digital, beamforming for a multiuser millimeter wave (mm-wave) relay system. For this system, we consider a sum rate maximization problem. The proposed hybrid beamforming is designed indirectly by…

Multicast beamforming is known to improve spectral efficiency. However, its benefits and challenges for hybrid precoders design in millimeter-wave (mmWave) systems remain understudied. To this end, this paper investigates the first joint…

Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…

Millimeter wave (mmWave) communications have been considered as a key technology for future 5G wireless networks. In order to overcome the severe propagation loss of mmWave channel, mmWave multiple-input multiple-output (MIMO) systems with…