相关论文: Detecting Ultrasound Vibrations by Graphene Resona…
We carried out measurements on nanoelectromechanical systems based on multilayer graphene sheets suspended over trenches in silicon oxide. The motion of the suspended sheets was electrostatically driven at resonance using applied…
Achieving optimal force sensitivity with nanomechanical resonators requires the ability to resolve their thermal vibrations. In two-dimensional resonators, this can be done by measuring the energy they absorb while vibrating in an optical…
In this work, a novel approach for the detection and localisation of nonlinear guided waves often associated with the presence of damage in structural components is proposed. The method is active and consists of a piezoelectric transducer…
Plasmons, collective oscillations of electron systems, can efficiently couple light and electric current, and thus can be used to create sub-wavelength photodetectors, radiation mixers, and on-chip spectrometers. Despite considerable…
We show that a graphene sheet perforated with micro- or nano-size antidots have prominent absorption resonances in the microwave and terahertz regions. These resonances correspond to surface plasmons of a continuous sheet "perturbed" by a…
We report on the detection of diffraction gratings buried below a stack of tens of 18 nm thick $\mathrm{SiO_2}$ and $\mathrm{Si_3N_4}$ layers and an optically opaque metal layer, using laser-induced, extremely-high frequency ultrasound. In…
Bolometers are a powerful and vital means of detecting light in the IR to THz frequencies, and they have been adopted for a range of uses from astronomical observation to thermal imaging. As uses diversify, there is an increasing demand for…
Graphene-based electromechanical resonators have attracted much interest recently because of the outstanding mechanical and electrical properties of graphene and their various applications. However, the coupling between mechanical motion…
We have investigated surface shear waves at 22 MHz in a 0.5-micron-thick polymer film on SiO2/Si substrate at low temperatures using suspended and non-suspended graphene as detectors. By tracking ultrasound modes detected by oscillations of…
Visualizing elastic waves by noninvasive imaging has been useful for analyzing the mechanical properties of materials and tissues. However, the maximum wave frequency of elastography has been limited to ~10 kHz due to the finite sensitivity…
The gravitational waveform of merging binary neutron stars encodes information about extreme states of matter. Probing these gravitational emissions requires the gravitational-wave detectors to have high sensitivity above 1 kHz. Fortunately…
High-frequency gravitational waves represent an unexplored frontier of gravitational physics. While pulsar timing arrays reach nHz frequencies and ground-based interferometers probe the audio band, the regime above the MHz scale remains…
We report a non-contact method for conductivity and sheet resistance measurements of graphene samples using a high Q microwave dielectric resonator perturbation technique, with the aim of fast and accurate measurement of microwave…
Mechanical resonators based on a single carbon nanotube are exceptional sensors of mass and force. The force sensitivity in these ultra-light resonators is often limited by the noise in the detection of the vibrations. Here, we report on an…
The spatial resolutions of even the most sensitive isotope analysis techniques based on light or ion probes are limited to a few hundred nanometres. Although vibration spectroscopy using electron probes has achieved higher spatial…
Tunability of the surface plasmon resonance wavelength is demonstrated by varying the thickness of Al2O3 spacer layer inserted between the graphene and nanoparticles. By varying the spacer layer thickness from 0.3 to 1.8 nm, the resonance…
We report radio frequency (rf) electrical readout of graphene mechanical resonators. The mechanical motion is actuated and detected directly by using a vector network analyzer, employing a local gate to minimize parasitic capacitance. A…
We investigated the effect of the electron-beam irradiation on the level of the low-frequency 1/f noise in graphene devices. It was found that 1/f noise in graphene reveals an anomalous characteristic - it reduces with increasing…
Resonance ultrasound spectroscopy (RUS) is a non-destructive technique used to assess materials' elastic and anelastic properties. It involves measuring the frequencies of free vibrations in a carefully prepared sample to extract material…
Graphene mechanical resonators have recently attracted considerable attention for use in precision force and mass sensing applications. To date, readout of their oscillatory motion has typically required cryogenic conditions to achieve high…