相关论文: P-doped organic semiconductor: potential replaceme…
Poly(3,4-ethylenedioxythiophene):poly(styrenesulfonate) (PEDOT:PSS) is widely used to build optoelectronic devices. However, as a hygroscopic water-based acidic material, it brings major concerns for stability and degradation, resulting in…
Oxygen plasma is a widely used treatment to change the surface properties of organic layers. This treatment is particularly interesting to enable the deposition from solution of poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate)…
We have performed resistivity measurements of poly[3,4-ethylenedioxythiophene]: poly[styrenesulfonate] (PEDOT:PSS) films with varying concentrations of glycerol. Resistivity is seen to decrease exponentially from roughly 3 ohm-cm for pure…
The performance of solution-processed organic light emitting diodes (OLEDs) is often limited by non-uniform contacts. In this work, we introduce Ni-containing solution-processed metal oxide (MO) interfacial layers inserted between indium…
Poly(3,4-ethylenedioxythiophene) : poly(styrene sulfonic acid (PEDOT:PSS), an optically transparent organic semi-conductor, constitutes a suspension of conducting PEDOT:PSS grains, shelled by an insulating layer of PSS. While a percolation…
We show that the highly conductive polymer poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS) can successfully be applied as a hole selective front contact in silicon heterojunction (SHJ) solar cells. In combination with a…
Photodiodes are widely used to convert lights into electrical signals. The conventional silicon (Si) based photodiodes boast high photoelectric conversion efficiency and detectivity. However, in general, inorganic-based photodiodes have low…
Poly(3,4-ethylenedioxythiophene):polystyrenesulfonate (PEDOT:PSS) has been widely used as a hole transport layer in perovskite solar cells (PSCs). However, the high interface defect density and energy level mismatch between PEDOT:PSS and…
"Secondary doping" in poly(3,4-ethylenedioxy-thiophene):poly(styrenesulfonate) (PEDOT:PSS) is quite effective and a frequently used method for the conductivity enhancement. This simple approach, the addition of co-solvents to the PEDOT:PSS…
Highly doped Poly(3,4-ethylenedioxythiophene) or PEDOT is a conductive polymer with a wide range of applications in energy conversion due to its ease of processing, optical properties and high conductivity. The latter is influenced by…
Polymer based printable organic thin film transistor (OTFT) is a viable low cost alternative to amorphous silicon based thin film transistors and possesses light-weight and flexibility advantage. In this paper, we report on the hole…
Organic photodetectors (OPDs) possess bright prospects in applications of medical imaging and wearable electronics due to the advantages such as low cost, good biocompatibility, and good flexibility. Photomultiplication OPDs (PM-OPDs)…
Perovskite solar cells (PSCs) with transparent electrodes can be integrated with existing solar panels in tandem configurations to increase the power conversion efficiency. A critical layer in semi-transparent PSCs is the inorganic buffer…
Despite the highly porous nature with significantly large surface area, metal organic frameworks (MOFs) can be hardly used in electronic, and optoelectronic devices due to their extremely poor electrical conductivity. Therefore, the study…
After the efficiency of organic photovoltaic (OPV) cells achieved more than 10%, the control of stability and degradation mechanisms of solar cells became a prominent task. The improvement of device efficiency due to incorporation of a…
We investigated the reversible resistive switching of poly(3,4-ethylenedioxythiophene):polystyrenesulfonate (PEDOT:PSS) thin films sandwiched between Al electrodes. The J-V sweep curve showed a hysteretic behavior which depends on the…
High-efficiency organic photocathodes, based on regioregular poly(3-hexylthiophene) and phenyl-C61-butyric acid methyl ester (rr-P3HT:PCBM) bulk heterojunction sandwiched between charge-selective layers, are emerging as efficient and…
We demonstrate that blending fluorinated molecules in PEDOT:PSS hole transport layers (HTL) induces charge transfers which impact on both charge extraction and photogeneration within organic photovoltaic (OPV) devices. OPVs fabricated with…
Using electrically detected magnetic resonance spectroscopy, we demonstrate that doping the conducting polymer poly(3,4-ethylenedioxythiophene):poly(styrene-sulfonate) (PEDOT:PSS) with ethylene glycol allows for the control of effective…
We report a method for producing an array of fifty two ion-sensitive PEDOT:PSS organic electrochemical transistors on a glass coverslip, each featuring an integrated fluoropolymer microwell sealed with lipid bilayer into which membrane…