相关论文: Hybrid Procoder and Combiner Design for Secure Tra…

This paper investigates the joint design of hybrid transmit precoder and analog receive combiners for single-group multicasting in millimeter-wave systems. We propose LB-GDM, a low-complexity learning-based approach that leverages gradient…

Despite its promising performance gain, the realization of mmWave massive MIMO still faces several practical challenges. In particular, implementing massive MIMO in the digital domain requires hundreds of RF chains matching the number of…

Multi-antenna precoding effectively mitigates the interference in wireless networks. However, the precoding efficiency can be significantly degraded by the overhead due to the required feedback of channel state information (CSI). This paper…

Hybrid precoding is a cost-effective approach to support directional transmissions for millimeter-wave (mm-wave) communications, but its precoder design is highly complicated. In this paper, we propose a new hybrid precoder implementation,…

In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…

Fifth generation (5G) wireless networks are expected to utilize wide bandwidths available at millimeter wave (mmWave) frequencies for enhancing system throughput. However, the unfavorable channel conditions of mmWave links, e.g., higher…

Although the benefits of precoding and combining of data signals are widely recognized, the potential of these techniques for pilot transmission is not fully understood. This is particularly relevant for multiuser multiple-input…

While fully-digital precoding achieves superior performance in massive MIMO systems, it comes with significant drawbacks in terms of computational complexity and power consumption, particularly when operating at millimeter-wave (mmWave)…

The UFMC modulation is among the most considered solutions for the realization of beyond-OFDM air interfaces for future wireless networks. This paper focuses on the design and analysis of an UFMC transceiver equipped with multiple antennas…

Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…

In this paper, we consider physical layer security provisioning in multi-cell massive multiple-input multiple-output (MIMO) systems. Specifically, we consider secure downlink transmission in a multi-cell massive MIMO system with…

Millimeter-wave (mmWave) communication is considered as an indispensable technique for the next-generation backhaul/fronthaul network thanks to its large transmission bandwidth. Especially for heterogeneous network (HetNet), the mmWave…

Multiuser beamforming is considered for partially-connected millimeter wave massive MIMO systems. Based on perfect channel state information (CSI), a low-complexity hybrid beamforming scheme that decouples the analog beamformer and the…

In this paper, we study the problem of physical layer security in large-scale multiple input multiple output (LS-MIMO) systems. The large number of antenna elements in LS-MIMO system is exploited to enhance transmission security and improve…

To circumvent the high path loss of mmWave propagation and reduce the hardware cost of massive multiple-input multiple-output antenna systems, full-dimensional hybrid beamforming is critical in 5G and beyond wireless communications.…

The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…

Invoking large transmit antenna arrays, massive MIMO wiretap settings are capable of suppressing passive eavesdroppers via narrow beamforming towards legitimate terminals. This implies that secrecy is obtained almost for free in these…

In this paper, we investigate the secure beamforming design in an intelligent reflection surface (IRS) assisted millimeter wave (mmWave) system, where the hybrid beamforming (HB) and the passive beamforming (PB) are employed by the…

Linear hybrid beamformer designs are conceived for the decentralized estimation of a vector parameter in a millimeter wave (mmWave) multiple-input multiple-output (MIMO) Internet of Things network (IoTNe). The proposed designs incorporate…

Hybrid beamforming has evolved as a promising technology that offers the balance between system performance and design complexity in mmWave MIMO systems. Existing hybrid beamforming methods either impose unit-modulus constraints or a…