相关论文: Optimal Energy Beamforming under Per-Antenna Power…

In multicell massive multiple-input multiple-output (MIMO) non-orthogonal multiple access (NOMA) networks, base stations (BSs) with multiple antennas deliver their radio frequency energy in the downlink, and Internet-of-Things (IoT) devices…

This correspondence studies the wireless powered over-the-air computation (AirComp) for achieving sustainable wireless data aggregation (WDA) by integrating AirComp and wireless power transfer (WPT) into a joint design. In particular, we…

This paper investigates the average throughput of a wireless powered communications system, where an energy constrained source, powered by a dedicated power beacon (PB), communicates with a destination. It is assumed that the PB is capable…

Characterizing the fundamental tradeoffs for maximizing energy efficiency (EE) versus spectrum efficiency (SE) is a key problem in wireless communication. In this paper, we address this problem for a point-to-point additive white Gaussian…

Energy efficiency of fixed-rate transmissions is studied in the presence of queueing constraints and channel uncertainty. It is assumed that neither the transmitter nor the receiver has channel side information prior to transmission. The…

In this letter, a novel wireless powered protocol is proposed to maximize the system throughput of an energy harvesting (EH) based cognitive radio network, while satisfying a minimum primary user rate requirement. For EH, we exploit both…

Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…

Energy Efficiency (EE) is a big issue in 5th Generation Wireless Communications (5G) on condition that the number of access User Equipments (UEs) are exploding and more antennas should be equipped in one Base Station (BS). In EE studies,…

This paper proposes energy-efficient coordinated beamforming strategies for multi-cell multi-user multiple-input single-output system. We consider a practical power consumption model, where part of the consumed power depends on the base…

The integrated radar and communication system is promising in the next generation wireless communication networks. However, its performance is confined by the limited energy. In order to overcome it, a wireless powered integrated radar and…

The dramatic increase of network infrastructure comes at the cost of rapidly increasing energy consumption, which makes optimization of energy efficiency (EE) an important topic. Since EE is often modeled as the ratio of rate to power, we…

This paper studies a novel training-free energy beam focusing approach for a near-field wireless power transfer (WPT) system with extremely large-scale antenna array (ELAA). In particular, we focus on the setup with one access point (AP)…

We propose techniques for optimizing transmit beamforming in a full-duplex multiple-input-multiple-output (MIMO) wireless-powered communication system, which consists of two phases. In the first phase, the wireless-powered mobile station…

Radio frequency (RF) wireless energy transfer (WET) is a key technology that may allow seamlessly powering future massive low-energy Internet of Things (IoT) networks. To enable efficient massive WET, channel state information…

This paper considers downlink multicast transmit beamforming for secure layered transmission systems with wireless simultaneous information and power transfer. We study the power allocation algorithm design for minimizing the total transmit…

Internet of Things (IoT) sustainability may hinge on radio frequency wireless energy transfer (RF-WET). However, energy-efficient charging strategies are still needed, motivating our work. Specifically, this letter proposes a time division…

In this paper, we study energy-efficient resource allocation in distributed antenna system (DAS) with wireless power transfer, where time-division multiple access (TDMA) is adopted for downlink multiuser information transmission. In…

Simultaneous wireless information and power transfer (SWIPT) provides a promising solution for enabling perpetual wireless networks. As energy efficiency (EE) is an im- portant evaluation of system performance, this thesis studies…

In this letter, we consider a typical scenario where the transmitter employs different power adaption methods, including the optimal rate and power algorithm, optimal rate adaption, channel inversion and truncated channel inversion, to…

In this paper, we propose a new beamforming design to maximize energy efficiency (EE) for multiple input single output interfering broadcast channels (IFBC). Under this model, the EE problem is non-convex in general due to the coupled…