相关论文: Multiuser Millimeter Wave Beamforming Strategies w…
Hybrid beamforming is a promising technology for 5G millimetre-wave communications. However, its implementation is challenging in practical multiple-input multiple-output (MIMO) systems because non-convex optimization problems have to be…
We investigate the multiuser scheduling problem in multiple-input multiple-output (MIMO) systems using orthogonal frequency division multiplexing (OFDM) and hybrid beamforming in which a base station (BS) communicates with multiple users…
In this paper, we focus on the phenomenon of beam misalignment in Millimeter-wave (mmWave) multi-receiver communication systems, and propose robust hybrid precoding designs that alleviate the performance loss caused by this effect. We…
Hybrid precoders and combiners are designed for cooperative cell-free multi-user millimeter wave (mmWave) multiple-input multiple-output (MIMO) cellular networks for low complexity interference mitigation. Initially, we derive an optimal…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
Milimeter wave (mmWave) band mobile communications can be a solution to the continuously increasing traffic demand in modern wireless systems. Even though mmWave bands are scarcely occupied, the design of a prospect transceiver should…
Hybrid precoding is an indispensable technique to harness the full potential of a multi-user massive multiple-input, multiple-output (MU-MMIMO) system. In this paper, we propose a new hybrid precoding approach that combines digital and…
Hybrid precoding is a cost-effective approach to support directional transmissions for millimeter-wave (mm-wave) communications, but its precoder design is highly complicated. In this paper, we propose a new hybrid precoder implementation,…
Generalized spatial modulation (GenSM) aided millimeter wave (mmWave) multiple-input multiple-output (MIMO) has recently received substantial academic attention. However, due to the insufficient exploitation of the transmitter's knowledge…
Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…
To enhance the multiplexing gain of two-receiver Multiple-Input-Single-Output Broadcast Channel with imperfect channel state information at the transmitter (CSIT), a class of Rate-Splitting (RS) approaches has been proposed recently, which…
Hybrid analog/digital precoding is a promising technology to cut down hardware cost in massive multi-input multi-output (MIMO) systems at millimeter wave frequencies. In this letter, we propose a joint beam selection scheme for analog…
Data transmission over the mmWave in fifth-generation wireless networks aims to support very high speed wireless communications. A substantial increase in spectrum efficiency for mmWave transmission can be achieved by using advanced hybrid…
In the conventional multiuser MIMO systems, user selection and scheduling has previously been used as an effective way to increase the sum rate performance of the system. However, the recent concepts of the massive MIMO systems (at…
This paper studies the beamforming design problem to achieve max-min fairness (MMF) in multibeam satellite communications. Contrary to the conventional linear precoding (NoRS) that relies on fully treating any residual interference as…
To achieve high data rates defined in 5G, the use of millimeter-waves and massive-MIMO are indispensable. To benefit from these technologies, an accurate estimation of the channel parameters is crucial. We propose a novel two-stage…
Hybrid analog-digital beamforming stands out as a key enabler for future communication systems with a massive number of antennas. In this paper, we investigate the hybrid precoder design problem for angle-of-departure (AoD) estimation,…
This paper considers a reconfigurable intelligent surface (RIS)-aided millimeter wave (mmWave) downlink communication system where hybrid analog-digital beamforming is employed at the base station (BS). We formulate a power minimization…
In this letter, we study the performance of a downlink multiuser massive multiple-input multiple-output (MIMO) system with sub-connected structure over limited feedback channels. Tight rate approximations are theoretically analyzed for the…
The concept of reconfigurable intelligent surface (RIS) has been proposed to change the propagation of electromagnetic waves, e.g., reflection, diffraction, and refraction. To accomplish this goal, the phase values of the discrete RIS units…