相关论文: Anomalous Amplification of a Homodyne signal via A…
We analyze the amplification by the Aharonov-Albert-Vaidman weak quantum measurement on a Sagnac interferometer [P. B. Dixon et al., Phys. Rev. Lett. 102, 173601 (2009)] up to all orders of the coupling strength between the measured system…
Precision measurements of ultra-small linear velocities of one of the mirrors in a Michelson interferometer are performed using two different weak-values techniques. We show that the technique of Almost-Balanced Weak Values (ABWV) offers…
We describe a weak value inspired phase amplification technique in a Sagnac interferometer. We monitor the relative phase between two paths of a slightly misaligned interferometer by measuring the average position of a split-Gaussian mode…
The weak measurement proposed by Aharonov and his colleagues extracts information of a physical quantity of the system by the post selection as the shifts of the argument of the probe wavefunction. The shift is called the weak value and is…
We experimentally realize a great precision enhancement in the small tilt measurement by using a Sagnac interferometer and balanced homodyne detection (BHD) of high-order optical modes, together with the weak value amplification (WVA)…
Weak value amplification (WVA) is a metrological protocol that amplifies ultra-small physical effects. However, the amplified outcomes necessarily occur with highly suppressed probabilities, leading to the extensive debate on whether the…
We show using statistically rigorous arguments that the technique of weak value amplification (WVA) does not perform better than standard statistical techniques for the tasks of single parameter estimation and signal detection. Specifically…
We study the amplification of rotation velocity with the Sagnac interferometer based on the concept of weak-value amplification. By using a different scheme to perform the Sagnac interferometer with the probe in momentum space, we have…
We report on the use of an interferometric weak value technique to amplify very small transverse deflections of an optical beam. By entangling the beam's transverse degrees of freedom with the which-path states of a Sagnac interferometer,…
Weak-value amplification (WVA) is a post-selection-based technique that amplifies weak physical signals by preparing nearly orthogonal pre- and post-selected quantum states. It is intrinsically limited by various kinds of technical noise,…
Recently, biased weak measurement(BWM) has shown higher precision than both conventional measurement and standard weak measurement(SWM) in optical metrology. In this paper, we propose a scheme of detecting rotation velocity in Sagnac's…
Weak-value amplification employs postselection to enhance the measurement of small parameters of interest. The amplification comes at the expense of reduced success probability, hindering the utility of this technique as a tool for…
The weak-value (WV) measurement proposed by Aharonov, Albert and Vaidman (AAV) has attracted a great deal of interest in connection with quantum metrology. In this work, we extend the analysis beyond the AAV limit and obtain a few main…
A protocol employing weak values (WVs) to obtain ultra sensitive amplification of weak signals in the context of a solid state setup is proposed. We consider an Aharonov-Bohm interferometer where both the orbital and the spin degrees of…
Weak-value amplification (WVA) has recently become an important technique for parameter estimation, owing to its ability to enhance the signal-to-noise ratio by amplifying extremely small signals with proper postselection strategies. In…
We measure a transverse momentum kick in a Sagnac interferometer using weak-value amplification with two postselections. The first postselection is controlled by a polarization dependent phase mismatch between both paths of a Sagnac…
We present a parameter estimation technique based on performing joint measurements of a weak interaction away from the weak-value-amplification approximation. Two detectors are used to collect full statistics of the correlations between two…
An interferometric arrangement is proposed in which the technique of weak value amplification is implemented in order to enlarge the effect of a single photon on the quadratures of a movable mirror of an optical cavity. The photon interacts…
Weak-value amplification (WVA) is a metrological protocol that effectively amplifies ultra-small physical effects, making it highly applicable in the fields of quantum sensing and metrology. However, the amplification effect is achieved…
By choosing more orthogonality between pre-selection and post-selection states, one can significantly improve the sensitivity in the general optical quantum metrology based on the weak-value amplification (WVA) approach. However, increasing…