相关论文: Mode instability thresholds for Tm-doped fiber amp…
We show by detailed numerical modeling that stimulated thermal Rayleigh scattering can account for the modal instability observed in high power fiber amplifiers. Our model illustrates how the instability threshold power can be maximized by…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump…
We experimentally analyze the average-power-scaling capabilities of ultrafast, thulium-doped fiber amplifiers. It has been theoretically predicted that thulium-doped fiber laser systems, with an emission wavelength around 2 um, should be…
We show by numerical modeling that saturation of the population inversion reduces the stimulated thermal Rayleigh gain relative to the laser gain in large mode area fiber amplifiers. We show how to exploit this effect to raise mode…
Using a numerical model we study the frequency dependence of mode coupling gain due to stimulated thermal Rayleigh scattering in step index, Yb doped, fiber amplifiers. The frequency at the gain peak is shown to vary with core size, doping…
We numerically model fiber amplifier performance near and slightly above the mode instability threshold. These results are compared with recently published experimental work. Using weakly amplitude modulated pump light we obtain qualitative…
We investigated the effct of pump wavelength on the modal instabilities (MI) in high power linearly-polarized Yb-doped fiber amplifiers. We built a novel semi-analytical model to determine the frequency coupling characteristics and power…
Transverse Mode Instability (TMI) which results from dynamic nonlinear thermo-optical scattering is the primary limitation to power scaling in high-power fiber lasers and amplifiers. It has been proposed that TMI can be suppressed by…
In this letter, the impact of pump configuration on the modal instabilities (MI) threshold of high power fiber amplifiers is investigated. Using a time dependent computer model based on the optical beam propagation method (BPM), the effect…
High-power fiber laser amplifiers have enabled an increasing range of applications in industry, medicine and defense. The power scaling for narrow-band amplifiers is currently limited by the transverse modal instability. Various techniques…
We present an all-fiber design for a Tm-based fiber amplifier that can tune over 1992-2065 nm with 300-350 W single-frequency (<100 kHz) output. Over 180 W is achieved out to 2085 nm with <10% ASE content without utilizing ASE spectral…
We report on detailed in-situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the TMI-threshold of a commercial LMA fiber with 25 micron core and 400 micron cladding was measured at…
We study the transverse mode instability (TMI) in the limit where a single higher-order mode (HOM) is present. We demonstrate that when the beat length between the fundamental mode and the HOM is small compared to the length scales on which…
We show how signal linewidth affects the gain of stimulated thermal Rayleigh scattering (STRS) which is responsible for mode instability in fiber amplifiers. The gain is reduced if the coherence time of the signal is less than the group…
In this study, we revealed the impact of the pumping scheme, fiber length, pumping power, and reflectivity of the output fiber Bragg grating on the performance of a Tm^3+ -doped fiber laser (TDFL) operating at a wavelength of 1.72 \mu m.…
We use a semi-analytical model of stimulated thermal Rayleigh scattering to present theoretical study of seed power on mode instability with the presence of photodarkening. The behavior of mode instabilities as a function of seed power has…
We present detailed studies of the effect of polarization on thermal-induced mode instability (MI) in ytterbium-doped fiber amplifiers. Based on a steady-state theoretical model, which takes both electric fields along the two principal axes…
In this contribution we investigate the transversal mode instability behavior of an ytterbium doped commercial 20/400 fiber and obtain 2.9 kW of output power after optimizing the influencing parameters. In this context, we evaluate the…
We develop a high-power narrow-linewidth fiber amplifier based on a tapered Yb-doped fiber. In the experiment, the narrow end of the tapered fiber is used as the input port of both pump source and signal light to form a robust all-fiber…
We report on the influence of core NA on thermal-induced mode instabilities (MI) in high power fiber amplifiers. Influence of core NA and V-parameter on MI has been investigated numerically. It shows that core NA has larger influence on MI…