相关论文: On-Board Beam Generation for Multibeam Satellite S…
In the present work, a multibeam satellite that employs aggressive frequency reuse towards increasing the offered throughput is considered. Focusing on the forward link, the goal is to employ multi-antenna signal processing techniques,…
Fully digital massive MIMO systems with large numbers (1000+) of antennas offer dramatically increased capacity gains from spatial multiplexing and beamforming. Designing digital receivers that can scale to these array dimensions presents…
For the multiuser multiple-input multiple-output (MIMO) downlink channel, the users feedback their channel state information (CSI) to help the base station (BS) schedule users and improve the system sum rate. However, this incurs a large…
In the beyond fifth-generation (B5G) and upcoming sixth-generation (6G) wireless communication systems, millimeter (mmWave) wave technology is a promising solution for offering additional bandwidth resources and mitigating spectrum…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Linear processing in the spatial domain at the base stations (BSs) and at the users of MIMO cellular systems enables the control of both inter-cell and intra-cell interference. A number of iterative algorithms have been proposed that allow…
This paper proposes a joint optimization framework for energy-efficient linear precoding and feeder-link-beam matching design in a multi-gateway multi-beam bent-pipe satellite communication system. The proposed scheme jointly optimizes the…
We propose an algorithm to maximize the instantaneous sum data rate transmitted by a base station in the downlink of a multiuser multiple-input, multiple-output system. The transmitter and the receivers may each be equipped with multiple…
Cell-free massive MIMO systems consist of many distributed access points with simple components that jointly serve the users. In millimeter wave bands, only a limited set of predetermined beams can be supported. In a network that…
The present work focuses on the forward link of a broadband multibeam satellite system that aggressively reuses the user link frequency resources. Two fundamental practical challenges, namely the need to frame multiple users per…
Beamforming techniques have been widely used in the millimeter wave (mmWave) bands to mitigate the path loss of mmWave radio links as the narrow straight beams by directionally concentrating the signal energy. However, traditional mmWave…
This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…
In this paper, we propose a sequential hybrid beamforming design for multi-link transmission over mmwave frequency bands. As a starting point, a baseline data communication link is established via traditional analog beamforming at both the…
We consider a multiple-input multiple-output (MIMO) relaying boardcast channel in downlink cellular networks, where the base station and the relay stations are both equipped with multiple antennas, and each user terminal has only a single…
Much stringent reliability and processing latency requirements in ultra-reliable-low-latency-communication (URLLC) traffic make the design of linear massive multiple-input-multiple-output (M-MIMO) receivers becomes very challenging.…
Hybrid analog and digital beamforming (HBF) has recently emerged as an attractive technique for millimeter-wave (mmWave) communication systems. It well balances the demand for sufficient beamforming gains to overcome the propagation loss…
Millimeter wave (mmWave) communication is one feasible solution for high data-rate applications like vehicular-to-everything communication and next generation cellular communication. Configuring mmWave links, which can be done through…
Low Earth Orbit (LEO) satellite networks are capable of improving the global Internet service coverage. In this context, we propose a hybrid beamforming design for holographic metasurface based terrestrial users in multi-altitude LEO…
The beamforming techniques have been recently studied as possible enablers for underlay spectrum sharing. The existing beamforming techniques have several common limitations: they are usually system model specific, cannot operate with…
Massive MIMO communication systems, by virtue of utilizing very large number of antennas, have a potential to yield higher spectral and energy efficiency in comparison with the conventional MIMO systems. In this paper, we consider uplink…