相关论文: Study of wavelength dependence of mode instability…
We use a semi-analytical model of stimulated thermal Rayleigh scattering to present theoretical study of seed power on mode instability with the presence of photodarkening. The behavior of mode instabilities as a function of seed power has…
We investigated the effct of pump wavelength on the modal instabilities (MI) in high power linearly-polarized Yb-doped fiber amplifiers. We built a novel semi-analytical model to determine the frequency coupling characteristics and power…
We revisit the problem of modulation instability (MI) in optical fibers, including higher-order dispersion terms, self-steepening, and Raman response. We derive expressions for the MI gain and use them to explore the role of self-steepening…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump…
We present detailed studies of the effect of polarization on thermal-induced mode instability (MI) in ytterbium-doped fiber amplifiers. Based on a steady-state theoretical model, which takes both electric fields along the two principal axes…
In this letter, the impact of pump configuration on the modal instabilities (MI) threshold of high power fiber amplifiers is investigated. Using a time dependent computer model based on the optical beam propagation method (BPM), the effect…
We investigate multi-wave mixing associated with the strongly pump depleted regime of induced modulation instability (MI) in optical fibers. For a complete transfer of pump power into the sideband modes, we theoretically and experimentally…
We show by detailed numerical modeling that stimulated thermal Rayleigh scattering can account for the modal instability observed in high power fiber amplifiers. Our model illustrates how the instability threshold power can be maximized by…
We numerically model fiber amplifier performance near and slightly above the mode instability threshold. These results are compared with recently published experimental work. Using weakly amplitude modulated pump light we obtain qualitative…
The influence of the phase fluctuation of the pump laser on the phase-correlation between the signal and idler modes of the output fields from as non-degenerate optical parametric oscillator operating above oscillation threshold was…
A multimode model of a continuously pumped atom laser is shown to be unstable below a critical value of the scattering length. Above the critical scattering length, the atom laser reaches a steady state, the stability of which increases…
We investigated experimentally and numerically the spectral control of modulation instability (MI) dynamics via the initial phase relation of two weak seed fields. Specifically, we show how second-order modulation instability dynamics…
We derive analytical expressions for the coherence in the onset of modulation instability, in excellent agreement with thorough numerical simulations. As usual, we start by a linear perturbation analysis, where broadband noise is added to a…
Photonic crystal fibers are used in fiber amplifiers and lasers because of the flexibility in the design of mode area and dispersion. However, these quantities depend strongly on the wavelength. The wavelength dependence of gain,…
An experimental study of the delayed threshold phenomenon in a Vertical Extended Cavity Semiconductor Emitting Laser is carried out. Under modulation of the pump power, the laser intensity exhibits a hysteresis behavior in the vicinity of…
We observe competition between the modulation instability (MI) and stimulated Brillouin scattering (SBS) in a 9.2-GHz broadband SBS slow light device, in which a standard 20-km-long single-mode LEAF fibre is used as the SBS medium. We find…
Wavefront shaping techniques allow the control of the transport of light through many types of scattering or complex media, among them multimode fibers. The case of a multimode fiber which is also a gain medium presents further intriguing…
Fiber lasers are widely used in various fields owing to their high efficiency, flexible transmission and excellent beam quality. In applications such as industrial manufacturing and defense systems, a higher output power is always desired.…
We report on detailed in-situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the TMI-threshold of a commercial LMA fiber with 25 micron core and 400 micron cladding was measured at…
Light scattering and localization in strongly scattering disordered systems is governed by the nature of the underlying eigenmodes, specially their spatial extension within the system. One of the main challenges in studying experimentally…