相关论文: Signaling Design of Two-Way MIMO Full-Duplex Chann…

We model the self-interference in a multiple input single output (MISO) full-duplex two-way channel and evaluate the achievable rate region. We formulate the boundary of the achievable rate region termed as the Pareto boundary by a family…

We propose techniques for optimizing transmit beamforming in a full-duplex multiple-input-multiple-output (MIMO) wireless-powered communication system, which consists of two phases. In the first phase, the wireless-powered mobile station…

In this paper we explore the use of full-duplex radio to improve the spectrum efficiency in a two-way relay channel where two sources exchange information through an multi-antenna relay, and all nodes work in the full-duplex mode. The…

We consider the problem of quantifying the Pareto optimal boundary in the achievable rate region over multiple-input single-output (MISO) interference channels, where the problem boils down to solving a sequence of convex feasibility…

The multiple-input multiple-output interference channel is considered with perfect channel information at the transmitters and single-user decoding receivers. With all transmissions restricted to single stream beamforming, we consider the…

In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) wireless multi-relay network, in which a source-destination pair both equipped with multiple antennas communicates through multiple half-duplex amplify-and-forward…

In this paper, we investigate the problem of two-way relay beamforming optimization to maximize the achievable sum-rate of a simultaneous wireless information and power transfer (SWIPT) system with a full-duplex (FD) multiple-input…

We study the two-user multiple-input single-output (MISO) Gaussian interference channel where the transmitters have perfect channel state information and employ single-stream beamforming. The receivers are capable of performing successive…

Existing beamforming-based full-duplex solutions for multi-antenna wireless systems often rely on explicit estimation of the self-interference channel. The pilot overhead of such estimation, however, can be prohibitively high in…

In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…

Beamforming has proven to be valuable in enabling full-duplex massive MIMO base stations, but doing so effectively often requires knowledge of the self-interference channel matrix H. Estimating this high-dimensional channel is costly in…

A receiver with perfect channel state information (CSI) in a point-to-point multiple-input multiple-output (MIMO) channel can compute the transmit beamforming vector that maximizes the transmission rate. For frequency-division duplex, a…

This paper investigates the performance of optimal single stream beamforming schemes in multiple-input multiple-output (MIMO) dual-hop amplify-and-forward (AF) systems. Assuming channel state information is not available at the source and…

This letter develops an optimum beamforming method for downlink transmissions in cell-free massive multiple-input multiple-output (MIMO) systems, which employ a massive number of distributed access points to provide concurrent services to…

In this paper we consider the problem of full-duplex multiple-input multiple-output (MIMO) relaying between multi-antenna source and destination nodes. The principal difficulty in implementing such a system is that, due to the limited…

A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…

The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…

We consider a multiple-input multiple-output (MIMO) relaying boardcast channel in downlink cellular networks, where the base station and the relay stations are both equipped with multiple antennas, and each user terminal has only a single…

It is well known that Multiple-Input Multiple-Output (MIMO) systems have high spectral efficiency, especially when channel state information at the transmitter (CSIT) is available. When CSIT is obtained by feedback, it is practical to…

This paper considers the multiple-input-single-output interference channel (MISO-IC) with interference decoding capability (IDC), so that the interference signal can be decoded and subtracted from the received signal. On the MISO-IC with…