相关论文: Load-Modulated Single-RF MIMO Transmission for Spa…

Single-Radio-Frequency (RF) Multiple-Input-Multiple-Output (MIMO) systems such as the spatial modulation (SM) system and the space shift keying (SSK) system have been proposed to pursue a high spectral efficiency while keeping a low cost…

Controlling the radar beam-pattern by optimizing the transmit covariance matrix is a well-established approach for performance enhancement in multiple-input-multiple-output (MIMO) radars. In this paper, we investigate the joint optimization…

This paper considers multiple-input multiple-output (MIMO) relay communication in multi-cellular (interference) systems in which MIMO source-destination pairs communicate simultaneously. It is assumed that due to severe attenuation and/or…

A wireless relay with multiple antennas is called a multiple-input-multiple-output (MIMO) switch if it maps its input links to its output links using "precode-and-forward." Namely, the MIMO switch precodes the received signal vector in the…

This paper proposes a communication model for multiuser multiple-input multiple-output (MIMO) systems based on large intelligent surfaces (LIS), where the LIS is modeled as a collection of tightly packed antenna elements. The LIS system is…

The focus of this paper is on beamforming in a millimeter-wave (mmW) multi-input multi-output (MIMO) setup that has gained increasing traction in meeting the high data-rate requirements of next-generation wireless systems. For a given MIMO…

The joint design of spatial channel assignment and power allocation in Multiple Input Multiple Output (MIMO) systems capable of Simultaneous Wireless Information and Power Transfer (SWIPT) is studied. Assuming availability of channel state…

We consider a multi-pair massive multiple-input multiple-output (MIMO) relay network, where the relay is equipped with a large number, N, of antennas, but driven by a far smaller number, L, of radio frequency (RF) chains. We assume that K…

We consider a reconfigurable intelligent surface (RIS) assisted multiple-input multiple-output (MIMO) system in the presence of scattering objects. The MIMO transmitter and receiver, the RIS, and the scattering objects are modeled as…

In a cooperative relay network, a relay node (R) facilitates data transmission to the destination node (D), when the latter is unable to decode the source node (S) data correctly. This paper considers such a system model and presents a…

In this paper, linear transceiver design for multi-hop amplify-and-forward (AF) multiple-input multiple-out (MIMO) relaying systems with Gaussian distributed channel estimation errors is investigated. Commonly used transceiver design…

In this paper, a highly-efficient single-switch-regulated resonant wireless power receiver with hybrid modulation is proposed. To achieve both high efficiency and good output voltage regulation, phase shift and pulse width hybrid modulation…

We propose a multiple-input multiple-output (MIMO)-based full-duplex (FD) scheme that enables wireless devices to simultaneously transmit information and harvest energy using the same time-frequency resources. In this scheme, for a MIMO…

We present an evolution of multiple-input multiple-output (MIMO) wireless communications known as the tri-hybrid MIMO architecture. In this framework, the traditional operations of linear precoding at the transmitter are distributed across…

The application of hybrid precoding in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems has been proved effective for reducing the number of radio frequency (RF) chains. However, the maximum number of independent data…

Since the introduction of massive MIMO (mMIMO), the design of a transceiver with feasible complexity has been a challenging problem. Initially, it was believed that the main issue in this respect is the overall RF-cost. However, as mMIMO is…

Rydberg atomic quantum receivers (RAQRs) are capable of receiving multi-band radio-frequency (RF) signals simultaneously, which are expected to break Chu's limit for classical electronic antennas. However, signals from different users will…

Millimeter wave multiple-input multiple-output (mmWave-MIMO) systems with small number of radio-frequency (RF) chains have limited multiplexing gain. Spatial path index modulation (SPIM) is helpful in improving this gain by utilizing…

The uplink where both the transmitter and receiver can use a large antenna array is considered. This is proposed as a method of antenna offloading and connecting small cell access points (SCAP) in a Two-Tier cellular network. Due to having…

Physical layer security (PLS) is a promising paradigm for safeguarding 6G wireless networks by exploiting the inherent characteristics of wireless channels. However, the efficiency of conventional PLS is often limited by fixed orientation…