相关论文: Load-Modulated Single-RF MIMO Transmission for Spa…

In this paper, we consider linear MIMO transceiver design for a cellular two-way amplify-and-forward relaying system consisting of a single multi-antenna base station, a single multi-antenna relay station, and multiple multi-antenna mobile…

Deploying massive number of antennas at the base station side can boost the cellular system performance dramatically. Meanwhile, it however involves significant additional radio-frequency (RF) front-end complexity, hardware cost and power…

Conventional multiple-input multiple-output (MIMO) systems mainly rely on fixed antenna arrays, which limits their capability to adapt the effective channel matrix to the propagation environment. Rotatable antennas (RAs), which enable…

Due to the high cost and low energy efficiency of the dedicated radio frequency (RF) chains, the number of RF chains in a millimeter wave (mmWave) multiple-input multiple-output (MIMO) system is usually limited from a practical point of…

The Internet of things (IoT) holds much commercial potential and could facilitate distributed multiple-input multiple-output (MIMO) communication in future systems. We study a distributed reception scenario in which a transmitter equipped…

In this paper, performance of a dual-hop cooperative multiple-input and multiple-output (MIMO) system is analyzed over Rayleigh faded channels. For the considered system model, non-regenerative MIMO scheme with transmit antenna selection…

The limited bandwidth of optical wireless communication (OWC) front-end devices motivates the use of multiple-input-multiple-output (MIMO) techniques to enhance data rates. It is known that very high multiplexing gains could be achieved by…

A novel transmission protocol is conceived for a multi-user, multi-relay, multiple-input--multiple-output orthogonal frequency-division multiple-access (MIMO-OFDMA) cellular network based on joint transmit and receive beamforming. More…

Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…

Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…

Multiple-input multiple-output (MIMO) systems play a key role in wireless communication technologies. A widely considered approach to realize scalable MIMO systems involves architectures comprised of multiple separate modules, each with its…

Reconfigurable antennas (RAs) are a promising technology to enhance the capacity and coverage of wireless communication systems. However, RA systems have two major challenges: (i) High computational complexity of mode selection, and (ii)…

With the goal of improving spectral efficiency, complex rotation-based precoding and power allocation schemes are developed for two multiple-input multiple-output (MIMO) communication systems, namely, simultaneous wireless information and…

Generalized spatial modulation (GSM) uses $N$ antenna elements but fewer radio frequency (RF) chains ($R$) at the transmitter. Spatial modulation and spatial multiplexing are special cases of GSM with $R=1$ and $R=N$, respectively. In GSM,…

In this paper, we consider the downlink of a massive multiple-input-multiple-output (MIMO) single user transmission system operating in the millimeter wave outdoor narrowband channel environment. We propose a novel receive spatial…

We consider a multiple-input multiple-output (MIMO) relaying boardcast channel in downlink cellular networks, where the base station and the relay stations are both equipped with multiple antennas, and each user terminal has only a single…

This article introduces an energy and spectral efficient multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) transmission scheme designed for the future sixth generation (6G) wireless communication…

In past 802.11 systems there is a single Radio Frequency (RF) chain on the Wi-Fi device. Multiple antennas use the same hardware to process the radio signal. So only one antenna can transmit or receive at a time as all radio signals need to…

In this paper, the multiple-input multiple-output (MIMO) transmit beampattern matching problem is considered. The problem is formulated to approximate a desired transmit beampattern (i.e., an energy distribution in space and frequency) and…

Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…