相关论文: Implementation and experience with luminosity leve…

We report on the atom optical manipulation of an atom laser beam. Reflection, focusing and its storage in a resonator are demonstrated. Precise and versatile mechanical control over an atom laser beam propagating in an inhomogeneous…

The PhaseII Upgrades of CMS are being planned for the High Luminosity LHC (HL-LHC) era when the mean number of interactions per beam crossing ("in-time pileup") is expected to reach ~140-200. The potential backgrounds arising from…

We present an experimental study of a four beam optical lattice using the light scattered by the atoms in the lattice. We use both intensity correlations and observations of the transient behavior of the scattering when the lattice is…

The luminosity calibration for the ATLAS detector at the LHC during pp collisions at sqrt(s) = 7 TeV in 2010 and 2011 is presented. Evaluation of the luminosity scale is performed using several luminosity-sensitive detectors, and…

Machine learning (ML) is a rapidly growing area of research in the field of particle physics, with a vast array of applications at the CERN LHC. ML has changed the way particle physicists conduct searches and measurements as a versatile…

The High Luminosity Large Hadron Collider (HL-LHC) at CERN is expected to collide protons at a centre-of-mass energy of 14\,TeV and to reach the unprecedented peak instantaneous luminosity of 5\,$-$\,7.5\,x\,$10^{34}$\,cm$^{-2}$s$^{-1}$…

With the increasing brightness of Light sources, including the Diffraction-Limited brightness upgrade of APS and the high-repetition-rate upgrade of LCLS, the proposed experiments therein are becoming increasingly complex. For instance,…

We apply optical pumping to prepare the lithium beam of our atom interferometer in a single hyperfine-Zeeman sublevel: we use two components of the D1-line for pumping the 7Li atoms in a dark state F,mF=+2 (or -2) sublevel. The optical…

Accurate primary beam calibration is essential for precise brightness measurements in radio astronomy. The VLA Low-band Ionosphere and Transient Experiment (VLITE) faces challenges in calibration due to the offset Cassegrain optics used in…

In polarized proton operation in the Relativistic Heavy Ion Collider (RHIC) coherent beam-beam modes are routinely observed with beam transfer function measurements. These modes can become unstable under external excitation or in the…

The CMS Level-1 trigger was used to select cosmic ray muons and LHC beam events during data-taking runs in 2008, and to estimate the level of detector noise. This paper describes the trigger components used, the algorithms that were…

Chapter 8 in High-Luminosity Large Hadron Collider (HL-LHC) : Preliminary Design Report. The Large Hadron Collider (LHC) is one of the largest scientific instruments ever built. Since opening up a new energy frontier for exploration in…

A new Beam Halo Monitor (BHM) detector system has been installed in the CMS cavern to measure the machine-induced background (MIB) from the LHC. This background originates from interactions of the LHC beam halo with the final set of…

The upgraded LHCb detector has started its Run 3 of data taking in 2022, with a completely overhauled DAQ system, reading out and processing the full detector data at every LHC bunch crossing (30 MHz average rate). At the same time, an…

The strategies for and the performance of the CMS silicon tracking system alignment during the 2015-2018 data-taking period of the LHC are described. The alignment procedures during and after data taking are explained. Alignment scenarios…

Usually, off-axis digital holographic microscopy requires a coherent light source in order to record a full-field hologram. Nevertheless, a LASER-based illumination leads to a non-negligible coherent noise, decreasing then the imaging…

By integrating a phase-only Spatial Light Modulator (SLM) into the illumination arm of a cylindrical-lens-based Selective Plane Illumination Microscope (SPIM), we have created a versatile system able to deliver high quality images by…

The role of the ILC final focus system (FFS) is to demagnify the beam to the sizes at the IP required to meet the ILC luminosity goals. The current design of final focus performs perfect chromaticity correction in both horizontal and…

A precision luminosity measurement is essential for LHC cross-section measurements to determine fundamental parameters of the standard model and constrain or discover beyond-the-standard-model phenomena. The luminosity of the CMS detector…

The High Luminosity upgrade of the CERN Large Hadron Collider (HL-LHC) requires new high-radiation tolerant silicon pixel sensors for the innermost part of the tracking detector in the CMS experiment. The innermost layer of the tracker,…