相关论文: Co-Phased 360-Degree Profilometry of Discontinuous…
We describe a theoretical analysis and experimental set-up of a co-phased 360-degree fringe-projection profilometer. This 360-degree profilometer is built using 2-projections and 1-camera and can digitize discontinuous solids with diffuse…
360-degrees digitalization of three-dimensional (3D) solids using a projected light-strip is a well established technique. These profilometers project a light-strip over the solid under analysis while the solid is rotated a full revolution.…
Fringe-projection profilometry with 1 camera and 1 fringe-projector is a well-known and widely used technique in optical metrology. Spatial-frequency multiplexing interferometry with several spatial-carriers having non-overlapping…
A phase-demodulation method for digital fringe-projection profilometry using the spatial and temporal Nyquist frequencies is presented. It allows us to digitize tridimensional surfaces using the highest spatial frequency ({\pi} radians per…
Phase shift profilometry has become a standard technique for recording the surface of an object using the projection of sinusoidal patterns. We present a method of projecting the patterns via a pair of single-mode optical fibers mounted…
Microscopic fringe projection profilometry is a powerful 3D measurement technique with a theoretical measurement accuracy better than one micron provided that the measured targets can be imaged with good fringe visibility. However,…
Phase-shifting structured illumination is a powerful technique used across diverse imaging modalities, including 3D surface measurement, quantitative phase imaging, and super-resolution microscopy. However, conventional implementations…
Co-phase and co-focus detection is one of the key technologies for large-aperture segmented mirror telescopes. In this paper, a new edge sensor based on fringes of equal thickness is developed, which can detect each segment's relative…
It is a challenge for Phase Measurement Profilometry (PMP) to measure objects with a large range of reflectivity variation across the surface. Saturated or dark pixels in the deformed fringe patterns captured by the camera will lead to…
The structured light projection technique is a representative active method for 3-D reconstruction, but many researchers face challenges with the intricate projector calibration process. To address this complexity, we employs an additional…
Structured light illumination is an active 3-D scanning technique based on projecting/capturing a set of striped patterns and measuring the warping of the patterns as they reflect off a target object's surface. As designed, each pixel in…
We propose a high signal-to-noise extended depth-range three-dimensional (3D) profilometer projecting two linear-fringes with close phase-sensitivity. We use temporal phase-shifting algorithms (PSAs) to phase-demodulate the two close…
Due to the rise of spherical cameras, monocular 360 depth estimation becomes an important technique for many applications (e.g., autonomous systems). Thus, state-of-the-art frameworks for monocular 360 depth estimation such as bi-projection…
One-shot full-field surface profilometry using digital diffractive-confocal imaging correlation microscope based on digital micromirror device is developed for one-shot microscopic 3D surface measurement. Optical configuration applies…
Phase is a fundamental resource for optical imaging but cannot be directly observed with intensity measurements. The existing methods to quantify a phase distribution rely on complex devices and structures. Here we experimentally…
The polyhedron projection for 360-degree video is becoming more and more popular since it can lead to much less geometry distortion compared with the equirectangular projection. However, in the polyhedron projection, we can observe very…
On 3D imaging, light field cameras typically are of single shot, and however, they heavily suffer from low spatial resolution and depth accuracy. In this paper, by employing an optical projector to project a group of single high-frequency…
Recently, end-to-end trainable deep neural networks have significantly improved stereo depth estimation for perspective images. However, 360{\deg} images captured under equirectangular projection cannot benefit from directly adopting…
Phase Measuring Deflectometry (PMD) acquires the two components of the local surface gradient via a sequence of two orthogonal sinusoidal fringe patterns that have to be displayed and captured separately. We will demonstrate that the…
We propose a novel projector-camera system (ProCams) in which each pixel has both projection and capturing capabilities. Our proposed ProCams solves the difficulty of obtaining precise pixel correspondence between the projector and the…