相关论文: Volume of Fluid (VOF) type advection methods in tw…
This paper proposes a comparison of four popular interface capturing methods : the volume of fluid (VOF), the standard level set (SLS), the accurate conservative level set (ACLS) and the coupled level set and volume of fluid (CLSVOF). All…
A wide variety of interface capturing methods have been introduced for simulating two-phase flows throughout the years. However, there is a noticeable dearth of literature focusing on objective comparisons between these methods, especially…
The Volume-of-Fluid (VoF) method for simulating incompressible two-phase flows is widespread in academic and commercial simulation software because of its many advantages: a high degree of volume conservation, applicability to unstructured…
We present a numerical method for interface-resolved simulations of evaporating two-fluid flows based on the volume-of-fluid (VoF) method. The method has been implemented in an efficient FFT-based two-fluid Navier-Stokes solver, using an…
Over the past decades, the volume-of-fluid (VOF) method has been the method of choice for simulating atomization processes, owing to its unique ability to discretely conserve mass. Current state-of-the-art VOF methods, however, rely on the…
We present a novel numerical method to solve the incompressible Navier-Stokes equations for two-phase flows with phase change, using a one-fluid approach. Separate phases are tracked using a geometric Volume-Of-Fluid (VOF) method with…
Multiphase, compressible and viscous flows are of crucial importance in a wide range of scientific and engineering problems. Despite the large effort paid in the last decades to develop accurate and efficient numerical techniques to address…
To predict liquid-gas two-phase flow phenomena, accurate tracking and prediction of the evolving liquid-gas interface is required. Volume-of-Fluid or VoF method has been used in the literature for computationally modeling of such flows. In…
The gVOF package includes a complete and self-contained set of routines for volume of fluid initialization, interface reconstruction and fluid advection, which are used to implement several accurate and efficient geometric volume of fluid…
A variational volume-of-fluid (VVOF) methodology is devised for evolving interfaces under curvature-dependent speed. The interface is reconstructed geometrically using the analytic relations of Scardovelli and Zaleski [1] and the advection…
Volume of fluid(VOF) method is a sharp interface method employed for simulations of two phase flows. Interface in VOF is usually represented using piecewise linear line segments in each computational grid based on the volume fraction field.…
The numerical modelling of convection dominated high density ratio two-phase flow poses several challenges, amongst which is resolving the relatively thin shear layer at the interface. To this end we propose a sharp discretisation of the…
The paper is concerned with an adjoint complement to the Volume-of-Fluid (VoF) method for immiscible two-phase flows, e.g. air and water, which is widely used in marine engineering due to its computational efficiency. The particular…
Geometric flux-based Volume-of-Fluid (VOF) methods are widely considered consistent in handling two-phase flows with high density ratios. However, although the conservation of mass and momentum is consistent for two-phase incompressible…
Accurate numerical modeling of surface tension has been a challenging aspect of multiphase flow simulations. The integral formulation for modeling surface tension forces is known to be consistent and conservative, and to be a natural choice…
An advanced Volume of Fluid (VOF) method is presented that enables performant three-dimensional Direct Numerical Simulations (DNS) of the interaction of two immiscible fluids in a gaseous environment with large topology changes, e.g.,…
A two-phase, low-Mach-number flow solver is created and verified for variable-density liquid and gas with phase change. The interface is sharply captured using a split Volume-of-Fluid method generalized for a non-divergence-free liquid…
Since viscoelastic two-phase flows arise in various industrial and natural processes, developing accurate and efficient software for their detailed numerical simulation is a highly relevant and challenging research task. We present a…
The moment-of-fluid method (MOF) is known as an extension of the volume-of-fluid method with piecewise linear interface construction (VOF-PLIC). In this study, several directional splitting advection algorithms are extended from the…
In spite of considerable progress, computing curvature in Volume of Fluid (VOF) methods continues to be a challenge. The goal is to develop a function or a subroutine that returns the curvature in computational cells containing an interface…