相关论文: Negative Poisson's Ratio in Single-Layer Black Pho…

The elastic properties of a material with spherical voids of equal volume are analysed using a new model, with particular attention paid to the hexagonal close-packed and the face-centred cubic arrangement of voids. Void fractions well…

Very recently, two-dimensional(2D) boron sheets (borophene) with rectangular structure has been grown successfully on single crystal Ag(111) substrates.The fabricated boroprene is predicted to have unusual mechanical properties. We…

We report the quasiparticle band gap, excitons, and highly anisotropic optical responses of few-layer black phosphorous (phosphorene). It is shown that these new materials exhibit unique many-electron effects; the electronic structures are…

The monolayer of black phosphorous, or phosphorene, has recently emerged as a new 2D semiconductor with intriguing highly anisotropic transport properties. Existing calculations of its intrinsic phonon-limited electronic transport…

When a two-dimensional material, adhered onto a compliant substrate, is subjected to compression it can undertake a buckling instability yielding to a periodic rippling. Interestingly, when black phosphorus flakes are compressed along the…

Using bases of fourth rank tensorial bases of complete Voigt's symmetry elaborated by Walpole we obtained expressions for inverse of Young's modulus E, inverse of shear modulus G and Poisson's ratio, which depend on components of the…

Against common sense, auxetic materials expand or contract perpendicularly when stretched or compressed, respectively, by uniaxial strain, being characterized by a negative Poisson's ratio $\nu$. The amount of deformation in response to the…

Under extensional strain, fiber networks can exhibit an anomalously large and nonlinear Poisson effect accompanied by a dramatic transverse contraction and volume reduction for applied strains as small as a few percent. We demonstrate that…

The graphene-like two-dimensional (2D) silicon carbide or siligraphene has attracted remarkable attentions, owing to its fascinating physical properties. Nevertheless, the first high-quality siligraphene, i.e., monolayer Si9C15 was…

Phosphorene has been rediscovered recently, establishing itself as one of the most promising two dimensional group-V elemental monolayers with direct band gap, high carrier mobility, and anisotropic electronic properties. In this letter,…

Using first principles calculations we showed that the electronic and optical properties of single layer black phosphorus (BP) depend strongly on the applied strain. Due to the strong anisotropic atomic structure of BP, its electronic…

We analyze the resonance energy transfer (RET) rate between quantum emitters (QEs) near a phosphorene/SiC interface under the effects of uniaxial strain. Using a low-energy tight-binding model, we describe the electronic structure of…

Black phosphorous is a layered material having a high capacity of 2596 mAh/g as a battery electrode, however it suffers from cracking due to high volume expansion during lithiation. These cracks causes loss of electrical contact in the…

In this paper, the bulge test is used to determine the mechanical properties of very thin dielectric membranes. Commonly, this experimental method permits to determine the residual stress (s0) and biaxial Young's modulus (E/(1-u)).…

In our analysis, we show that Baldelli and Bourdin's work is only valid when describing the behaviour of a film bonded to an elastic pseudo-foundation, where Poisson's ratios of both bodies are in between -1 and 0 or in between 0 and 0.5…

Atomic structure of single-crystalline black phosphorus was studied by high resolution synchrotron-based photoelectron diffraction (XPD). The results show that the topmost phosphorene layer in the black phosphorus is slightly displaced…

Newly fabricated monolayer phosphorene and its few-layer structures are expected to be promising for electronic and optical applications because of their finite direct band gaps and sizable but anisotropic electronic mobility. By…

Elastic properties of soft, three-dimensional dimers, interacting through site-site n-inverse-power potential, are determined by computer simulations at zero temperature. The degenerate crystal of dimers exhibiting (Gaussian) size…

Strain engineering can effectively tune the electronic, topological and piezoelectric properties of materials. In this work, the small strain (-4\% to 4\%) effects on piezoelectric properties of $\alpha$-AsP monolayer are studied by density…

An incremental (or tangent) bulk modulus for finite isotropic elasticity is defined which compares an increment in hydrostatic pressure with the corresponding increment in relative volume. Its positivity provides a stringent criterion for…